Abstract:Flow characteristics of turbulent impinging jets issuing, respectively, from a rectangular and a square nozzles have been investigated numerically through the solution of three-dimensional Navier-Strokes equations in steady state. Two geometries with two nozzle-to-plate spacings of four and eight times of hydraulic diameters of the jet pipes, and two Reynolds numbers of 20000 and 30000 have been considered with fully developed inlet boundary conditions. An RNG based k–ε turbulence model and a deferred correction QUICK scheme in conjunction with the wall function method have been applied to the prediction of the flow fields within semi-confined spaces. A common feature revealed by the computational results is the presence of a toroidal recirculation zone around the jet. An adverse pressure gradient is found at the impingement surface downstream the stagnation point. Boundary layer separation will occur if the gradient is strong enough, and the separation manifests itself as a secondary recirculation zone at the surface. In addition, three-dimensional simulations reveal the existence of two and four pronounced streamwise velocity off-center peaks at the cross-planes near to the impingement plate, respectively, in the rectangular and square impinging jet flows. These peaks are found forming at the horizontal planes where the wall jets start forming accompanied by two or four pairs of counter-rotating vortex rings. It is believed that the formation of the off-center velocity peaks is due to the vorticity diffusion along the wall jet as the jet impinges on the target plate.

Three-Dimensional Jet Calculation for the Vertical Launcher on a Warship

Three-Dimensional Calculations and Tests of a Double-Nozzle Rocket Jet

Numerical simulation research of high altitude reverse jet flow for stage separation of missile

Analysis of Interaction Flowfields of Multiple Lateral Jets

Numerical Solution for Outlet Attitude of the Missile Vertical Launched from a Submarine

Numerical Simulation of High-Speed Jet Flow Field of Underwater Jet Propulsion Craft

A Numerical Study of the Interior Flow for Underwater Launched Missile

An Investigation of Ventilated Cavitating Flow in Vertical Launching of a Missile

Numerical Simulation and Study of the Separation Process of Missile Booster

Simulation of Jet Flow During Missile Launching with Dynamic Mesh

Numerical simulation on three-dimensional subsonic impinging jet

Work Properties of Inlet Pipeline of Metal/Water Ramjet

3D Unsteady Numerical Simulation of Missile Launching

Numerical Simulation of the Supersonic and Under-Expanded Jet Flow

Three-Dimensional Simulation of Turbulent Rectangular and Square Impinging Jet Flows

Three dimension numerical simulation of a jet device control channel

Research on the jet influence on the mechanical launcher of various ignition height

Numerical Simulation of the Fluid Flows Around a Missile with Thrust-Vectoring Control System Launched Underwater

Three-Dimensional Simulation Of Thermal Discharge Into Offshore Water Areas

Numerical Analysis of Complex Flowfields Around Multi-Wing Missiles and Its Aerodynamic Force Computations

Flow Behavior During Uncorking Process of an Underwater Hot-Launched Missile