Abstract:Unexpected pressure rise may occur in the end-burning grain solid rocket motor. It is generally believed that this phenomenon is caused by the nonparallel layer combustion of the burning surface, resulting in the increase of burning rate along the inhibitor. In order to explain the cause of this phenomenon, the experimental investigation on four different end configurations were carried out. Based on the X-ray real-time radiography (RTR) technique, a new method for determining the dynamic burning rate of propellant and obtaining the real-time end-burning profile was developed. From the real-time images of the burning surface, it is found that there was a phenomenon of nonuniform burning surface displacement in the end-burning grain solid rocket motor. Through image processing, the real-time burning rate of grain center line and the real-time cone angle are obtained. Based on the analysis of the real-time burning rate at different positions of the end surface, the end face cone burning process in the motor working process is obtained. The closer to the shell, the higher the burning rate of the propellant. Considering the actual structure of this end-burning grain motor, it is speculated that the main cause of the cone burning of the grain may be due to the heat conduction of the metal wall. By adjusting the initial shape of the grain end surface, the operating pressure of the combustion chamber can be basically unchanged, so as to meet the mission requirements. The results show that the method can measure the burning rate of solid propellant in real time and provide support for the study of nonuniform combustion of solid propellant.

EXPERIMENTAL STUDY OF ANOMALOUS COMBUSTION IN SOLID PROPELLANT GRAIN WITH DEFECTS

EXPERIMENTAL STUDY OF TYPICAL DEFECT PROPAGATION PROCESSES IN SOLID ROCKET MOTORS

Experimental Investigation Of Crack/Debond Propagation Process In Burning Test Motor

Experimental Study on Effect of Grain with Defects on Solid Rocket Motor

TWO TYPES OF CRACKS ON CAVITY SURFACE OF HIGH-LOADED SOLID PROPELLANT GRAIN

Research on the Safety of Long Term Storage Solid Rocket Motor with Debonded Layer

Expérimental investigation on crack combustion and flow in solid propellant

Factors influence propagation of debond in burning propellant

Burning Rate Enhancement Analysis Of End-Burning Solid Propellant Grains Based On X-Ray Real-Time Radiography

The Experimental Research into Failure of a Solid Propellant on Micro-Scale

Design of the debonding propagation in burning propellant

Deformation of Solid Propellant Grains under Axial Acceleration Load

Analysis of the Surface Cracks of Long Range Storage Solid Motor Grain

Solid Propellant Charge Defect Detection Based on Endoscopic Detection Technology

Investigation of Combusting Flow Field in Composite Propellant Cracks

An Experimental Study on Dynamic Deformation and Ignition Response of a Novel Propellant under Impact Loading

Damage-ignition Mechanism Studies on Modified Propellant with Different Crosslinking Density under Dynamic Loading

Research Progress on Structural Integrity of Solid Rocket Motor Grain

Experimental study of particle trajectories in solid rocket motor chamber

THE BASIC PATTERNS OF COUPLING BETWEEN CONVECTIVE COMBUSTION AND CRACK PROPAGATION OF SOLID PROPELLANT

Research progress in dynamic mechanical behavior of solid propellants