Abstract:The Nyquist wavelength-division multiplexing technique enable a solution to achieve high spectral efficiency in long-haul transmission system. Compare to polarization division multiplexing quadrature-phase-shift-keying, even high-level modulation scheme such as polarization division multiplexing 16-quadrature-amplitude-modulation is much more sensitive to intra-channel noise and inter-channel linear crosstalk caused by Nyquist wavelength-division multiplexing. We experimentally demonstrated the generation and transmission of the 6 × 128-Gb/s Nyquist wavelength-division multiplexing sixteen quadrature amplitude modulation signal over 1200-km single-mode fiber (SMF)-28 with Erbium-doped fiber amplifier only amplification with a net SE of 7.47 b/s/Hz, which is so far, to our knowledge, the highest SE for the signal with the bit rate above 100-Gb/s using the polarization-division multiplexing 16-quadrature-amplitude-modulation format. This experiment was successfully enabled by digital-signal-processing (DSP) pre-equalization of transmitter-side impairments and DSP post-equalization of the channel and receiver-side impairments. Nyquist-band is considered in the pre- equalization to enhance the tolerance of the polarization-division multiplexing 16-quadrature-amplitude-modulation to the aggressive spectral shaping. The bit error rate for each of the 6 channels is smaller than the limitation of the forward-error-correction limit of 3.8 ×10-3 after 1200-km SMF-28 transmission.

8 × 10Gb/s high speed WDM transmission experiment over 80km standard single-mode fiber

8×250 Gbit/s PAM4 Transmission over 1 Km Single Mode Fiber with an All-Silicon LAN WDM Transmitter.

43 Gb/s DWDM optical transmission system using NRZ format and electro-absorption modulation

16×10.7 Gb/s transmission over 1600 km of single-mode fiber with gain equalization filter and dispersion-management

Field Transmission of I OOG and Beyond: Multiple Baud Rates and Mixed Line Rates Using Nyquist-WDM Technology

Field Transmission of 100 G and Beyond: Multiple Baud Rates and Mixed Line Rates Using Nyquist-WDM Technology

High-Speed PDM-RZ-8QAM DWDM Transmission (160 $\times$ 114 Gb/s) over 640 Km of Standard Single-Mode Fiber

Transmission of 10gb/s Wdm Signals over 4000 Km of Standard Single-Mode Fiber with 106 Km Spans Using All-Raman Amplification and Nrz Format

10Gb/s Optical Internet Network with 16-Channel Bi-Directional Dwdm Transmission System

8X622mb/s Hd-Wdm Optical Fiber Transmission over 420 Km

2.4Gb/s, 50km optical fiber transmission using Ti:LiNbO3 external modulator

Experimental Demonstration of Four-Channel WDM 560 Gbit/s 128QAM-DMT Using IM/DD for 2-km Optical Interconnect

Transmission of 42.8-Gb/s Polarization Multiplexed RZ-QPSK DWDM Signals over 3900 Km with 12.5-Ghz Channel Spacing and Coherent Detection

Demonstration of 1.6 Tbit/s (40 × 40 Gbit/s) Wavelength Division Multiplexing 160 km Straight Line Transmission Experiments

Single Wavelength 248-Gb/s transmission over 80-km SMF Based on Twin-SSB-DMT and Direct Detection

WDM Transmission of 108.4-Gbaud PDM-QPSK Signals (40×433.6-Gb/s) over 2800-Km SMF-28 with EDFA Only

6.4 Tb/s (32×200 Gb/s) WDM Direct-Detection Transmission with Twin-Ssb Modulation and Kramers–Kronig Receiver

7 $\,\times\,$ 224 Gb/s/ch Nyquist-WDM Transmission over 1600-Km SMF-28 Using PDM-CSRZ-QPSK Modulation

Two-channel Optical FDM Transmission Experiment over 50 Km Using an In-Line Optical-Fiber Amplifier

6 128-Gb/s Nyquist-WDM PDM-16QAM Generation and Transmission Over 1200-km SMF-28 With SE of 7.47 b/s/Hz

4.096 Tbit/s multidimensional multiplexing signals transmission over 1000 km few mode fiber