Abstract:Background: Pulse width, which can reflect qi, blood excess, and deficiency, has been used for diagnosing diseases and determining the prognosis in traditional Chinese medicine (TCM). This study aimed to devise an objective method to measure the pulse width based on an array pulse diagram for objective diagnosis. Methods: The channel 6, the region wherein the pulse wave signal is the strongest, is located in the middle of the pulse sensor array and at the guan position of cunkou during data collection. Therefore, the main wave (h1) time of the pulse wave was collected from the channel 6 through calculation. The left h1 time was collected from the remaining 11 channels. The amplitudes at these time points were extracted as the h1 amplitudes for each channel. However, the pulse width could not be calculated accurately at 12 points. Consequently, a bioharmonic spline interpolation algorithm was used to interpolate the h1 amplitude data obtained from the horizontal and vertical points, yielding 651 (31 × 21) h1 amplitude data. The 651 data points were converted into a heat map to intuitively calculate the pulse width. The pulse width was calculated by multiplying the number of grids on the vertical axis with the unit length of the grid. The pulse width was determined by TCM doctors to verify the pulse width measurement accuracy. Meanwhile, a color Doppler ultrasound examination of the volunteers' radial arteries was performed and the intravascular meridian widths of the radial artery compared with the calculated pulse widths to determine the reliability. Results: The pulse width determined using the maximal h1 amplitude method was comparable with the radial artery intravascular meridian widths measured using color Doppler ultrasound. The h1 amplitude was higher in the high blood pressure group and the pulse width was greater. Conclusions: The pulse width determined using the maximal h1 amplitude was objective and accurate. Comparison between the pulse widths of the normal and high blood pressure groups verified the reliability of the method.

Simulation study of pulse wave in the radial artery

Computer Simulation of Pulse Wave

[A Digital Simulation Study on the Effect of Change in Cardiovascular System Parameters on the Pulse Waveform of the Radial Artery].

Beating Heart Modeling and Simulation

Model Design and System Implementation for the Study of Anti-motion Artifacts Detection in Pulse Wave Monitoring

Simulation of Blood Pressure Wave Propagation in A Vessel by One-Dimensional Model

Analysis of the Radial Pulse Wave and its Clinical Applications: A Survey

Simulating Cardiovascular Haemodynamics By Bond Graph Technique

Estimation of central pulse wave velocity from radial pulse wave analysis

Simulation study of the cardiovascular functional status in hypertensive situation.

Study of pulse wave phenomena associated with blood flow model in human viscoelastic artery

Interpretable and accurate curve‐fitting method for arterial pulse wave modeling and decomposition

A Novel Interpretation for Arterial Pulse Pressure Amplification in Health and Disease

Bond graph model for cardiovascular system

Assessment of arteriosclerosis based on lognormal fitting

The Investigation of Bio-impedance Analysis at a Wrist Phantom with Two Pulsatile Arteries

Relation Between Blood Pressure and Pulse Wave Velocity for Human Arteries

Objective Evaluation of Pulse Width Using an Array Pulse Diagram

Numerical Simulation in the Abdominal Aorta and the Visceral Arteries with or Without Stenosis Based on 2D PCMRI

Improving the accuracy and robustness of carotid-femoral pulse wave velocity measurement using a simplified tube-load model

Non-invasive assessment by B-mode ultrasound of arterial pulse wave intensity and its modification during ventricular dysfunction