Abstract:Abstract During strong ground motions, members of reinforced concrete structures undergo cyclic deformations and experience permanent damage. Members may lose their initial stiffness as well as strength. Recently, Los Alamos National Laboratory has performed experiments on scale models of shear wall structures subjected to recorded earthquake signals. In general, the results indicated that the measured structural stiffness decreased with increased levels of excitation in the linear response region. Furthermore, a significant reduction in strength as well as in stiffness was also observed in the inelastic range. Since the in-structure floor response spectra, which are used to design and qualify safety equipment, have been based on calculated structural stiffness and frequencies, it is possible that certain safety equipment could experience greater seismic loads than specified for qualification due to stiffness reduction. In this research, a hysteresis model based on the concept of accumulated damage has been developed to account for this stiffness degradation both in the linear and inelastic ranges. Single and three degrees of freedom seismic Category I structures were analyzed and compared with equivalent linear stiffness degradation models in terms of maximum displacement responses, permanent displacement, and floor response spectra. The results indicate significant differences in responses between the hysteresis model and equivalent linear stiffness degradation models. The hysteresis model is recommended in the analysis of reinforced concrete shear-wall structures to obtain the in-structure floor response spectra for equipment qualification. Results of both cumulative and one shot tests are compared.

Elasto Plastic Analysis of Reinforced Concrete Slit Shear Walls

NON-LINEAR SEISMIC RESPONSE OF REINFORCED CONCRETE SLIT SHEAR WALLS

Analytical Model for Steel Frame-Reinforced Concrete Infill Slit Wall System

Elasto-Plastic Analysis Of Reinforced Concrete Shear Wall With Openings Using A Macro Model

Study on a Seismic Slit Shear Wall with Cyclic Experiment and Macro-Model Analysis

Direct Strut-and-Tie Model for Ultimate Shear Strength of Reinforced Concrete Structural Walls

Experimental Study of Steel Plate Composite Shear Wall Units under Cyclic Load

Elasto-Plastic Seismic Shear Distributions of Frame-Wall Structures

Research on the Performance of Slotted Reinforced Concrete Shear Wall Filled with Viscoelastic Material

ELASTIC BUCKLING ANALYSIS OF TWO-SIDED CONNECTION STEEL PLATE SHEAR WALL WITH SLITS

Nonlinear Earthquake Response Analysis and Energy Calculation for Seismic Slit Shear Wall Structures

NONLINEAR FINITE ELEMENT ANALYSIS OF WALL STRUCTURE FILLED WITH VISCOELASTIC MATERIAL

Inelastic Analysis of Reinforced Concrete Shear Wall Structures under Seismic Excitation

ELASTO-PLASTIC DYNAMIC ANALYSIS OF DUAL FUNCTIONAL SHEAR WALL WITH BUILT-IN SLITS

ELASTIC BUCKLING BEHAVIOR OF STEEL PLATE SHEAR WALLS SLOTTED AT TWO EDGES

Seismic Analysis and Design of Composite Shear Wall with Stiffened Steel Plate and Infilled Concrete

Static Elasto-Plastic Analysis of RC Shear Walls with One Row Openings

Study on a New Shear Wall System with Shaking Table Test and Finite Element Analysis

Analysis of Elastic Behaviors for Dual Function Slitted Shear Wall

Experimental study on the seismic behaviour of composite shear walls with stiffened steel plates and infilled concrete

Design and Analysis of Slotted Shear Walls Equipped with Energy Dissipating Shear Connectors