Abstract:This paper presents an experimental and theoretical study of surface generation in the ultra-precision grinding of hard and brittle materials. The study takes into account the material properties, the relative vibration between the grinding wheel and the workpiece, the machining parameters and the phase shift of the grinding process. The Taguchi approach is employed to study the influence of machining parameters on the surface quality and shows that the feed speed and rotational speed of the workpiece are key factors. Experiments have been conducted to study individual variables, and the results further show that the feed rate and the cross-feed distance have a significant effect on surface generation. It is found that the spirals around the central area of the workpiece are the primary mechanism for surface generation, which originates from the synchronous relative tool-work vibration. The integral part of the ratio of the rotational speed of the grinding wheel to rotational speed of the workpiece determines the number of spirals and its fractional part controls the spiral geometry. A theoretical model for predicting the single spiral generation has been developed to explain the accumulation of the phase shift and the geometry. The changeable feed speed near the end of grinding is also modelled, revealing the approximate straight lines around one circle in the central region. The simulated results indicate that the theoretical models and the ground surfaces are in close agreement. The scallop-height model is developed to calculate the influence of phase shift on surface quality, and it is found that the phase shift near the medium value can effectively improve surface quality. Finally, a comparison of different surface generation mechanisms in grinding mould steel, tungsten carbide (WC) and reaction bonded silicon carbide (RB-SiC) is made. It is interesting to note that the Spanzipfel effect contributes to the surface generation not only on ductile materials such as mould steel but also on brittle materials such as WC and RB-SiC. The Spanzipfel effect is the most significant in grinding mould steel. For WC and RB-SiC, the ground surface contains both a ductile region and a brittle region in the form of micro-fractures.

Surface finish and chip formation resulting from electrolytic in-process grinding

Nano-Precision Synergistic Finishing Process Integrated ELID-Grinding and MRF

Formation Mechanism and Simulation of Oxide Film in Electrodeless ELID Grinding

Research Progresses of ELID Mirror Grinding Technology

Studies on the Surface Quality of the Unsteady-State Grinding Technique

Mirror Surface Grinding by Metal Bonded Super-abrasive Wheel with Electrolytic In-process Dressing

Influences of grinding parameters on flexural strength in the grinding of Li-spinel ferrites with electroplated diamond wheel

Application of ELID Grinding Technique to Precision Machining of Optics

Mirror Surface Grinding of Steel Bonded Carbides

Electrolytic In-Process Dressing Grinding of Arc Groove with Workpiece Swing

Cavitation Effect in Ultrasonic-Assisted Electrolytic In-Process Dressing Grinding of Nanocomposite Ceramics

Mirror micro-relief grinding mechanism of TiC series steel-matrix carbide alloys

Understanding of highly-oriented 3C-SiC ductile-brittle transition mechanism in ELID ultra-precision grinding

Surface Properties of Ultrasonic Vibration-Assisted ELID Grinding ZTA Ceramics

Finish Surface Grinding of Titanium Alloys

An experimental and theoretical analysis of surface generation in the ultra-precision grinding of hard and brittle materials

Mechanism and machinability in novel electroplastic-assisted grinding ductile iron

Micro-Grinding of Electrochemically Pretreated Ultra-high-Chromium Steel

Ductile deformation and subsurface damage evolution mechanism of silicon wafer induced by ultra-precision grinding process

Subsurface Damage and Bending Strength Analysis for Ultra-Thin and Flexible Silicon Chips

A study on wear mechanism and wear reduction strategies in grinding wheels used for ELID grinding