Abstract:There have been many research reports on the reinforcement of small-sized square columns with a cross-section of 200mm-300mm using prestressed carbon fiber-reinforced polymer (CFRP) materials, while there are few studies on piers in bridge and tower columns in cable-stayed bridges with a cross-section of several meters or even tens of meters. The horizontal prestressed steel tendons in the anchorage zone of tower columns in cable-stayed bridge replaced by prestressed CFRP sheets can not only facilitate construction and maintenance, but also have good fatigue resistance. The prestressed CFRP plate is used to reinforce the large-sized tower columns by using a specific device to tension the CFRP plate wrapped around the surface of the members. The tensioning device and test pedestal based on WSGG (wave-shaped-gear-grip) anchor clamping of CFRP plate have been developed in this paper, and the CFRP plate circumferential tensioning tests on the pedestal have been conducted. The test results are as follows: (1) the developed device can achieve circumferential tensioning of single-layer CFRP plate to 0.5ftk of the material, reaching a tensile force of 60kN, and generate effective restraint pressure on a 2-m long composite compression component; (2)The calculation formula for the constraint pressure generated by the circumferential prestressed CFRP sheet on the component has been derived and verified, and the maximum error between the calculated value and the experimental value is within 5%; (3) When iron sheet serves as the interface medium between CFRP plate and compression components, the prestress loss of the CFRP plate tensioned at one end is about 84% and 58%-60% when tensioned at both ends. It can be seen that the effective prestress of the CFRP plate with iron sheet as the interface medium is relatively small. Meanwhile, based on the distribution of compressive stress in the components and the effective pre tension value of CFRP plate, it can be seen that two end tensioning is better than one end tensioning; (4) The tensile stress of CFRP plate along the member is a cubic function when the tension force is 60kN, so it is deduced that the constrained compressive stress generated by CFRP plate on the member is a quadratic function distribution.

Research and application of the large deflection of the phase to phase composite spacer

Study of the post buckling behaviours for the phase to phase composite spacer

Mechanical Analysis and Calculation of Phase-to-phase Composite Spacer on 750 Kv Compact Transmission Lines

Research on 500 Kv Phase to Phase Composite Spacer for Compact Lines

Experimental Research on Composite Action of Concrete-filled RPC Tube under Axial Load

Extreme Bending of Composite Insulators on 750 Kv Compact Transmission Lines

Configuration of phase-to-phase spacer on 1000 kV compact transmission line

Configuration of Phase-to-phase Spacer on 1 000 Kv Compact Transmission Line

Analytical and Experimental Study of Lateral and Distortional Buckling of FRP Wide-Flange Beams

Experimental study on large-scale compression members strengthened with circumferential prestressed CFRP plate

Simulation Research on the Suppression Effect of Spacers on 1000 kV UHV AC Compact Transmission Lines Under Comprehensive Conditions

A novel double bridging-slipping (DBS) concept to overcome deformation incompatibility of textile reinforced-engineering cementitious composite (TR-ECC)

Research on the Compression-Bending Behavior of Concrete-Filled Double-Steel-plate Composite Bridge Towers

EXPERIMENTAL AND ANALYTICAL EVALUATION OF LATERAL BUCKLING OF FRP COMPOSITE CANTILEVER I-BEAMS

Development And Experimental Verification Of Design Equations For Frp Beams

Design and Application of Arched Structure Beam with FRP

Static and Ultimate State Analysis of Cfrp Double-Layer Grids

Axial compressive behavior of concrete-filled FRP-steel wire reinforced thermoplastics pipe hybrid columns

Numerical simulation on structural behavior of FRP profile‐concrete hybrid beams with bolt shear connector

Deflection calculating method of damaged concrete beams strengthened with BFRP

Experimental Research and Fnite Element Analysis on Steel Bridge Deck in CFRP Reinforced SFRC Pavements