Abstract:The famous thermal response factor g-function proposed by Eskilson has been widely used for thermal behavior analysis of borehole heat exchangers (BHEs). However, the necessary prerequisite to g-function is the assumption of uniform borehole wall temperature, which has not been comprehensively clarified in literatures yet. Unlike the g-function type solutions, a novel three-dimensional (3D) semi-analytical solution is developed for thermal behavior analysis of single U-tube BHEs without pre-imposing borehole wall condition. Instead, the new solution can provide vertical temperature and heat flux profiles along borehole wall. Studies indicate that a new dimensionless parameter of heat carrying capacity (HCC) can be defined to quantify the relative capacity of convective heat transfer of fluid flow in tube to heat conduction in soil. It is shown that thermal capacity of the single U-tube BHEs can be efficiently improved by increasing heat carrying capacity of low HCCs, and the BHEs with high HCCs (>1.692) exhibit the same thermal behavior as the infinite HCC BHE. Effects of HCC on borehole wall conditions are also examined with the semi-analytical solution. It is revealed that the variation along the borehole wall becomes smaller with increasing HCCs. For the two assumptions commonly used in literatures, the uniform borehole wall temperature assumption can be adopted when HCCs are high, while the uniform borehole wall flux assumption is unreasonable and should be used cautiously. Further study suggests that the g-function solution can be used to formulate an approximate solution for the average fluid temperature when HCC is higher than 0.458, by which the computation cost can be reduced effectively.

Calculation of thermal group constants and borehole temperature correction in the neutron logging numerical simulation

Numerical Calculation Scheme of Neutronics-Thermal-Mechanical Coupling in Solid State Reactor Core Based on Galerkin Finite Element Method

Numerical Simulation of Natural Convection and Calculation of Heat Transfer Coefficient in Wellbore Annulus during Deep-Water Gas Well Testing

Numerical Study on Determining Formation Porosity Using a Boron Capture Gamma Ray Technique and MCNP

2D Transient Simulation of Conjugate Natural Convection and Radiation Within Thermal Wellbore Annuli

Calculation of Porosity and CO2 Content in CO2-Bearing Gas Formations Based on Density and Neutron Logging Forward and Inverse Methods

Monte Carlo Simulation In Nuclear Well Logging

Numerical simulation of the thermal interaction between pumping and injecting well groups

Numerical Simulation of Unsteady-State Flow in Dual Porous Coalbed Methane Horizontal Wells with Complex Boundary Conditions

Experimental study of the influence of borehole parameters on prompt fission neutron uranium logging and its corrections

Real-Time Simulation of Neutron Space-Time Kinetics for High-Temperature Gas-Cooled Reactor

Simulation Study of the Channel on Correcting Neutron Self-Shielding Effect in Bulk Coal

A fast and accurate semi-analytical method to determine the thermal response of bore fields

Prediction of Temperature and Pressure Distribution in HTHP Injection Gas Wells with Thermal Effect of Wellbore

Numerical Manifold Method for Thermal–hydraulic Coupling in Fractured Enhance Geothermal System

Transport Correction Method of PWR Anisotropic Scattering

Numerical simulation of flow and heat transfer in natural gas well bore

A new method for calculating bulk density in pulsed neutron-gamma density logging

A Novel Semi-Analytical Solution for Thermal Response Analysis of Single U-Tube Borehole Heat Exchangers (Bhes)

Generalized Perturbation Theory Based Total Sensitivity and Uncertainty Analysis for High-Fidelity Neutronics Calculation

Leakage Correction in Group-Constant Generation for Pebble-Bed HTGRs