Abstract:Tsinghua University is currently developing a very-high-frequency electron gun that operates in continuous-wave (cw) mode at 216.667 MHz. This gun will serve as the beam source for the Shanghai high repetition rate XFEL and extreme light facility. The cavity profile has been optimized to minimize input power, peak surface electric field, and peak wall power density. The profile optimization also takes into account the suppression of multipacting effect. Additionally, thermal analysis has been performed to guide the design of water cooling channels in coordination with gun mechanical design. The fabrication of the gun has been completed, and the frequency and quality factor measured in cold test are in good agreement with simulation expectations. During high power conditioning, 75 kW cw radio frequency power was successfully fed into the gun, corresponding to a cathode gradient of 27 MV/m and a gun voltage of 780 keV. This operating gradient is currently the highest in the world for room-temperature VHF guns. Under this condition, the maximum dark current collected by the Faraday cup at the gun exit was 376 nA when the strength of the gun solenoid was scanned. To measure and optimize the beam quality, a test beamline was constructed. After preliminary optimization, the 95% projected transverse emittance was 0.161 mm mrad for 10 pC bunches with a bunch length of 0.49 mm rms, 0.429 mm mrad for 50 pC bunches with a bunch length of 1.15 mm rms, and 0.853 mm mrad for 100 pC bunches with a bunch length of 1.44 mm rms.

Physical Design of FEL Injector Based on the Performance-Enhanced EC-ITC RF Gun

The design of high-brightness ERL-FEL injector based on VHF electron gun

Design of a New DC-RF Injector Used in High Average Power FEL

DC-SC photocathode injector for high average power FEL

Design of RF Chopper System for Improving Beam Quality in FEL Injector with Thermionic Gun

DC-SC Photocathode Infector for High Average Power FEL

Research on DC-RF superconducting photocathode injector for high average power FELs

Longitudinal phase space improvement of a continuous-wave photoinjector toward X-ray free-electron laser application

Optimized Design for High-Current, Low-Emmittance Photocathode RF Gun

Large-angle, gigahertz-rate random telegraph switching induced by spin-momentum transfer

Start-to-end simulation of the injector for a compact THz source

Beam dynamics studies of the photo-injector in low-charge operation mode for the ERL test facility at IHEP

Design of a Compact C-band High Brightness Photoinjector for an Ultra-Fast Electron Diffraction

A fully plasma based electron injector for a linear collider or XFEL

Superstructures For High Current Fel Application

Nonlinearly Shaped Pulses in Photoinjectors and Free-Electron Lasers

Multiplexed Photoinjector Optimization for High-Repetition-Rate Free-Electron Lasers

Design, Fabrication, and Beam Commissioning of a 216.667 MHz Continuous-Wave Photocathode Very-High-frequency Electron Gun

Design of FEL by the EEHG scheme at Tsinghua University

R&D of a multi cavity RF gun with thermionic cathode for BFEL