Response of Critical Tube Diameter Phenomenon to Small Perturbations for Gaseous Detonations

N. Mehrjoo,B. Zhang,R. Portaro,H. D. Ng,J. H. S. Lee
DOI: https://doi.org/10.1007/s00193-013-0491-2
IF: 1.903
2013-01-01
Shock Waves
Abstract:In this experimental study, the critical tube diameter phenomenon of gaseous detonations is investigated in both stable and unstable mixtures with focus on the failure mechanism. It was previously postulated that in unstable mixtures, where the cellular detonation front is highly irregular, the failure is caused by the suppression of local re-initiation centers linked to the dynamics of instabilities. In stable mixtures, typically with high argon dilution, the detonation structure is very regular and the failure mode is attributed to the excessive curvature of the global front. In order to differentiate between these two failure mechanisms, flow perturbations are introduced by placing an obstacle resulting in a minimal blockage ratio of approximately 8 %. The obstacle is placed at the tube exit, before the detonation diffraction. Results show that the perturbations caused by the obstacle only have an effect on undiluted (i.e., unstable) mixtures, causing a decrease in the minimum initial pressure required for successful detonation transmission. This thus demonstrates that local hydrodynamic instabilities play an important role for the critical tube diameter phenomenon in undiluted, unstable mixtures. In contrast, the results for the stable, argon-diluted mixture exhibit little variation in critical initial pressure between the perturbed and unperturbed cases. This can be attributed to the minimal effect of the perturbations on global curvature for the emergent detonation wave. The geometry of the perturbation is also tested, while holding the blockage area constant, by varying the number and position of the obstacle(s). The results demonstrate that the transmission of a detonation is independent of the blockage geometry and is only a function of its imposed blockage area. Consequently, the change in required minimum pressure for transmission shows an identical behavior in unstable mixtures for different perturbation geometries while the transmission characteristics of the stable mixture remain unaffected.
What problem does this paper attempt to address?