Abstract:The current control methods play an important role in power electronic circuits, particulary in current regulated PWM inverters which are widely applied in ac motor drives and continuous ac power supplies where the objective is to produce a sinusoidal ac output. The main task of the control systems in current regulated inverters is to force the current vector in the three phase load according to a reference trajectory. In this paper, two hysteresis current control methods (hexagon and square hysteresis based controls) of three-phase voltage source inverter (VSI) have been implemented. Both controllers work with current components represented in stationary (α, β) coordinate system. Introduction Three major classes of regulators have been developed over last few decades: hysteresis regulators, linear PI regulators and predictive dead-beat regulators [1]. A short review of the available current control techniques for the threephase systems is presented in [2]. Among the various PWM technique, the hysteresis band current control is used very often because of its simplicity of implementation. Also, besides fast response current loop, the method does not need any knowledge of load parameters. However, the current control with a fixed hysteresis band has the disadvantage that the PWM frequency varies within a band because peak-topeak current ripple is required to be controlled at all points of the fundamental frequency wave. The method of adaptive hysteresis-band current control PWM technique where the band can be programmed as a function of load to optimize the PWM performance is described in [3]. The basic implementation of hysteresis current control is based on deriving the switching signals from the comparison of the current error with a fixed tolerance band. This control is based on the comparison of the actual phase current with the tolerance band around the reference current associated with that phase. On the other hand, this type of band control is negatively affected by the phase current interactions which is typical in three-phase systems. This is mainly due to the interference between the commutations of the three phases, since each phase current not only depends on the corresponding phase voltage but is also affected by the voltage of the other two phases. Depending on load conditions switching frequency may vary during the the fundamental period, resulting in irregular inverter operation. In [4] the authors proposed a new method that 1 minimize the effect of interference between phases while maintaining the advantages of the hysteresis methods by using phase-locked loop (PLL) technique to constrain the inverter switching at a fixed predetermined frequency. In this paper, the current control of PWM-VSI has been implemented in the stationary (α, β) reference frame. One method is based on space vector control using multilevel hysteresis comparators where the hysteresis band appear as a hysteresis square. The second method is based on predictive current control where the three hysteresis bands form a hysteresis hexagon. Model of the Three-Phase VSI The power circuit of a three-phase VSI is shown in figure 1. The load model is consisting of a sinusoidal inner voltage e and an inductance (L).

Asymmetry Three-Level Gird-Connected Current Hysteresis Control with Varying Bus Voltage and Virtual Oversample Method

Current Prediction and Virtual Over-Sampling Based Digital Hysteresis Control

Multi-stage Virtual Over-sample Digital Hystersis Control

An Improved Virtual Inertia Control for Three-Phase Voltage Source Converters Connected to a Weak Grid

A hysteresis loop control method for output current of three-phase photovoltaic grid-connected inverters

Stability Analysis and Improvement of Three-Phase Grid-Connected Power Converters with Virtual Inertia Control

A digital hysteresis control method for three-level grid-tie inverter based on online prediction of sampling time without inductance

Current Harmonic Suppression For Grid-Connected Vsg Based On Virtual Harmonic Impedance

Sliding mode current control of grid-connected voltage source converter

Improved predictive current control of grid-connected DC-AC converters under unbalanced grid voltage conditions

Model-Free Predictive Current Control of a Multilevel Cascaded H-bridge inverter for Photovoltaic Systems

Decoupled Unipolar Hysteresis Current Control for Single-Phase Grid-Tied Inverter Without Current Zero-Crossing Distortion

Dc-Link Ripple Suppression of Cascaded H-Bridge Based MV Grid Emulator Apparatus for Analysis and Testing of Grid-Tied Converters in Distribution System

A Configurable Virtual Impedance Method for Grid-Connected Virtual Synchronous Generator to Improve the Quality of Output Current

Three-level photovoltaic inverter technology based on repetitive control

Predictive Current Control for Grid-Connected Inverters under Unbalanced Grid Voltage

Analysis and Benchmarking of Grid-Forming Control for Power Converters

A novel control method for dual mode time-sharing grid-connected inverter

Hysteresis Current Control in Three-Phase Voltage Source Inverter Mirjana Milošević

Asymmetrical High Voltage Ride Through Control Strategy of Grid-Side Converter for Grid-Connected Renewable Energy Equipment

A Hybrid Multi-loop Current Control of the Grid-Connected Converter with LCL Filter