Abstract:Converter dust (LT dust) is an important solid waste from steelmaking, in which iron oxides are the preferred raw material for preparing high value-added a-Fe2O3. Since LT dust contains many impurities, the iron oxides in the LT dust must be enriched and purified before the preparation of a-Fe2O3. Particle trapping behaviors of the matrices as well as the magnetic flocculation of LT dust particles in superconducting high gradient magnetic separation (S-HGMS) were investigated with numerical simulations and experiments. The geometric shape, aspect ratio a:b, and angle a between the axis and the magnetic field direction of the matrices affected the maximum magnetic field intensity (H-max) and effective capture area (S-eca). Diamond matrices had better particle-capture capacity than elliptic and circular matrices because the diamond matrices produced a tip effect and increased the magnetic field force. When the cross section of the matrices was parallel to the direction of the particle velocity, magnetic/weakly magnetic particles were more easily captured by the upper and lower ends of the matrices compared with that of two sides because the particle velocity at the upper and lower ends of the matrices was smaller than that of two sides, making the magnetic force greater than the drag force. Fe2MgO4 and Fe2O3 particles were more prone to magnetic flocculation than other particles because of their higher magnetic susceptibility. The dispersant changed the pH of the solution and the charges on the surface of LT dust particles, and the particles were effectively dispersed because of the action of electrostatic forces. When the magnetic induction was 1.8 T, the dispersant dosage was 20 mg/L, the pulp concentration was 1.5%, and the total Fe content increased by 8.72%, corresponding to an Fe recovery of 91.65%. Finally, a method was developed for extracting iron oxides from LT dust using S-HGMS, to prepare high value-added a-Fe2O3.

Effect of Feed Solids on High Gradient Magnetic Separation of Cylindrical Magnetic Matrix

Coupling effect between magnetic wires and its influence on high gradient magnetic separation performance

Particle Capture Efficiency in a Multi-Wire Model for High Gradient Magnetic Separation

A simulation on field distribution and particle capture characteristics in a multi-wire PHGMS system

Development and performance of a permanent magnet pulsating separator

Separation of Iron from Converter Dust by Superconducting HGMS: A Simulation Analysis and Experimental Study

Analysis on the Assembled Magnetic Media Application in the Magnetic Separator

Effects of magnet arrangement on the separation behavior of magnetic particles in high-concentration suspensions based on numerical simulations: Magnetic force induced eddies

Calculation of Evaluation Variables for High Gradient Magnetic Separation with an Idealized Capture Model

Investigation of particle capture by grooved plates with elliptic teeth for high intensity magnetic separation

Physical Design of High Gradient Superconducting Magnetic Separation Magnet for Kaolin

Mechanical characteristics of magnetite as a function of particle size during column-based magnetic separation

A three-product magnetic-separation column: influence of compound force field on the settlement of magnetite

Feasibility Study of Iron Mineral Separation from Red Mud by High Gradient Superconducting Magnetic Separation

Enhancing the separation of refractory weakly magnetic minerals with magnetic fluid in high gradient magnetic separation: Conversion of competing capture to mechanical entrainment

Removal of phosphate from wastewater by using open gradient superconducting magnetic separation as pretreatment for high gradient superconducting magnetic separation

A Study of Processing High-Grade Magnetite Concentrates by Combination of Magnetic Separation and Reverse Flotation Separation to Prepare Raw Materials for Ferrite Magnet

EFFECTS ON PARAMETERS OF DRY-TYPE HIGH MAGNETIC SEPARATION TO LOW GRADE POWER MINERAL

The Development of 5.5 T High Gradient Superconducting Magnetic Separator

Testing of a 5.5 T High-Gradient Superconducting Magnetic Separator

Application Of Superconducting High Gradient Magnetic Separation Technology On Silica Extraction From Iron Ore Beneficiation Tailings