Abstract:In response to the demand for short-range detection of anti-smoke environment interference by laser fuzes,this study proposes a smoke environment simulation of non-uniform continuous point source diffusion and investigates an experimental laboratory smoke environment using an ammonium chloride smoke agent.The particle size distribution,composition,and mass flow distribution of the smoke were studied.Based on a discrete phase model and a k-ε turbulence model,a numerical simulation was developed to model the smoke generation and diffusion processes of the smoke agent in a confined space.The temporal and spatial distribution characteristics of the smoke mass concentration,velocity,and temperature in the space after smoke generation were analyzed,and the motion law governing the smoke diffusion throughout the entire space was summarized.Combined with the experimental veri-fication of the smoke environment laboratory,the results showed that the smoke plume changed from fan-shaped to umbrella-shaped during smoke generation,and then continued to spread around.Meanwhile,the mass concentration of smoke in the space decreased from the middle outward;the changes in temperature and velocity were small and stable.In the diffusion stage(after 900 s),the mass concentration of smoke above 0.8 m was relatively uniform across an area of smoke that was 12 m thick.The concentration decreased over time,following a consistent decreasing trend,and the attenuation was negligible in a very short time.Therefore,this system was suitable for conducting experimental research on laser fuzes in a smoke environment.Owing to the stability of the equipment and facilities,the setup could reproduce the same experimental smoke environment by artificially controlling the smoke emission of the smoke agent.Overall,this work provides a theoretical reference for subsequent research efforts regarding the construction of uniform smoke environments and evaluating laser transmission characteristics in smoky environments.

Measurement of the Smoke Layer Interface in Fires

Analysis of Temporal and Spatial Distribution Characteristics of Ammonium Chloride Smoke Particles in Confined Spaces

EXPERIMENTAL STUDY ON AIR ENTRAINMENT COEFFICIENT DURING ONE-DIMENSIONAL HORIZONTAL MOVEMENT OF FIRE-INDUCED SMOKE IN LONG CHANNELS

Calculation Method and Experimental Validation for Interface Height of Smoke Layer with Low Temperature

New Approaches to Determine the Interface Height of Fire Smoke Based on a Three‐layer Zone Model and Its Verification in Large Confined Space

An Improved Method for Determining The Interface Height of Smoke Layer in A Tunnel Fire

Experimental measurements, integral modeling and smoke detection of early fire in thermally stratified environments

Determination of Smoke Layer Interface Height of Medium Scale Tunnel Fire Scenarios

A Novel Protocol to Measure the Attenuation of Electromagnetic Waves Through Smoke

A Method for Measurement & Evaluation of Infrared Smode

Improved Temperature-Based Methods and Deep Learning-Based Method for Identifying the Smoke Layer Height in Tunnel with Longitudinal Ventilation

Early fire smoke movements and detection in high large volume spaces

A Two-Dimension Velocity Field Measurement Method for the Thermal Smoke Basing on the Optical Flow Technology

Experimental Study on Fire Smoke Movement in a Multi-Floor and Multi-Room Building

Dynamic Smoke Particle Size Distribution in Test Fire

Smoke Filling in Closed Compartments with Elevated Fire Sources

Research on Early Fire Smoke Movements and Detection Method in Stable Thermally Stratified Environments

Numerical Study on the Change of Smoke Layer Length in Large Space Building Fires

Smoke Obscuration Measurements in Reduced-Scale Fire Modelling Based on Froude Number Similarity

An Experimental Study on the Effect of Fire Location on the Smoke Hazard in a Typical Building Structure Apparatus

Experimental Research on the Spatial Distribution of Toxic Gases in the Transport of Fire Smoke