Abstract:High cost of custom-made conventional turbines and the lack of local manufacturing facilities have created significant obstacles to the development of Pico/micro hydroelectric schemes in the country. In this context it has been identified pump as turbine (PAT) electric schemes can have distinct advantages over conventional turbines because pumps are manufactured locally at mass scale and available in various sizes. But not all pumps are suitable for use as PAT because they have different design details and manufacturing qualities. The performance of a pump used as a turbine is assessed based on two primary parameters: turbine mode head and flow at the Best Efficiency Point (BEP). There are various methods available in the literature for predicting PAT theoretical head and flow at BEP. These methods aim to estimate how the pump will perform when used as a turbine. Despite these prediction methods, there is a consistent deviation of approximately ±20% between the theoretical estimates and the actual measured performance. This indicates that real-world conditions and factors not accounted for in theoretical models can significantly affect the performance of PAT systems. The primary objective of the present study was to measure the deviation between the actual performance and the predicted performance of two PAT systems in terms of head and flow at BEP. This deviation was then compared to the commonly mentioned figure of ±20% in the literature. The study focused on using what it considered to be the most accurate prediction method among those presented in the literature to estimate PAT head and flow at BEP and involved running reverse, 1.1 kW, and 1.6 kW direct-drive standard centrifugal type water pumps in a test rig to measure the actual performance of the two PATs. The results of the study showed a deviation of +27% and -22% between the actual measured head and flow at BEP, and the values predicted by the theoretical method. This deviation is slightly outside the commonly mentioned range of ±20% found in the literature, but this is not expected to have a detrimental effect on the generation of electric power. This implies that, even with the observed slight deviation, the prediction method used in this study can be satisfactorily employed to estimate PAT head and flow at BEP.

Theoretical and Numerical Study of Performance Prediction of Centrifugal Pumps As Turbines

Experimental and numerical investigations on pressure pulsation in a pump mode operation of a pump as turbine

Performance Prediction of Centrifugal Pump Based on the Method of Numerical Simulation

Theoretical, experimental, and numerical methods to predict the best efficiency point of centrifugal pump as turbine

Theoretical Model of Energy Performance Prediction and BEP Determination for Centrifugal Pump As Turbine

Effect of Relative Positions between Blade and Volute Tongue on Prediction of Performance in Simulation of Centrifugal Pump

Numerical Simulation and Computational Flow Characterization Analyses of Centrifugal Pump Operating as Turbine

Selection and Performance Prediction of a Pump as a Turbine for Power Generation Applications

Numerical Simulation and Performance Experiment on Pump and Pump as Turbine

Numerical Research of Pump-as-Turbine Performance with Synergy Analysis

Prediction method of centrifugal pump running in turbine mode based on losses analysis

Numerical Investigation of Flow Field and Energy Loss in a Centrifugal Pump as Turbine

A Comparative Study between Theoretical and Measured Performance of Standard Centrifugal Pumps Running as Turbines

Hydrodynamic Behavior of a Pump as Turbine under Transient Flow Conditions

Research on rotational speed to the influence of pump as turbine

The pump as a turbine: A review on performance prediction, performance improvement, and economic analysis

Performance Prediction and Geometry Optimization for Application of Pump as Turbine: A Review

Study on the Impact of Blades Wrap Angle on the Performance of Pumps As Turbines Used in Water Supply System of High-Rise Buildings

A Numerical Analysis of the Effect of Impeller Rounding on Centrifugal Pump as Turbine

Experimental study of a centrifugal pump operating as a hydraulic turbine

Numerical prediction on over-all performance of double suction pump reverse running as turbine