Composites of Carbons/Indium Sulfide for Hydrogen Peroxide Production and Water Purification
Akshay Tikoo,A.K.S Koushik,Praveen Meduri,Koushik A.K.S
DOI: https://doi.org/10.1149/ma2023-02472356mtgabs
2023-12-22
ECS Meeting Abstracts
Abstract:Photocatalysis enables room temperature synthesis of hydrogen peroxide (H 2 O 2 ) without any byproducts as well as offering advantages such as low cost, and no release of toxic chemicals [1]. Thus, photocatalysis is an appealing approach for the environmentally friendly synthesis of H 2 O 2 . Two-dimensional (2D) layered transition metal chalcogenide (TMC) photocatalysts are good at light harvesting due to their high specific surface area and exhibit excellent optoelectronic properties which make them suitable for environmental remediation and energy production [2]. Metal sulfides have a narrower band gap, which improves their light absorption ability in the visible spectrum. However, they often suffer from low quantum yield and high charge recombination rate. Carbonaceous materials have been proven as very effective co-catalysts with semiconductors at increasing their photoactivity and decreasing recombination rate [3]. The present study focusses on indium sulfide (In 2 S 3 ) and its composites with carbon nano tubes (CNTs) and carbon quantum dots (CQDs) for H 2 O 2 generation via two-electron oxygen reduction reaction. In 2 S 3 , In 2 S 3 -CNT and In 2 S 3 -CQD are synthesized via hydrothermal method. Structural and optical properties characterized using several techniques such as XRD, Raman, UV-Vis-DRS, PL spectra, SEM, TEM etc. show high crystallinity of In 2 S 3 lattice, good dispersion of carbons on In 2 S 3 lattice, improved light absorption and decrease in recombination rate in In 2 S 3 carbon composites. Photoelectric properties are studied using chronoamperometry, EIS, cyclic voltammetry etc. The In 2 S 3 carbon composites show good stability and lower charge transfer resistance and higher active surface area than pure In 2 S 3 . The carbon composite materials show a significantly higher performance than the pure In 2 S 3 . In 2 S 3 -CQD achieves H 2 O 2 production rate of 634 μM h -1 , which is ~ 17 times higher than that of pure In 2 S 3 . These composites also show good performance for water treatment with In 2 S 3 -CQD removing 93% chromium(VI) and 94% rhodamine B (RhB) from contaminated water upon 2h of irradiation. The mechanism of removal of the impurities is also discussed. In 2 S 3 -CQD has shown good results owing to their good light absorption, high specific surface area, and CQDs being able to act as electron reservoir. Keywords : Photocatalysis, Hydrogen peroxide photosynthesis, Advanced Oxidation processes, Wastewater Treatment. References [1] M. Melchionna, P. Fornasiero, Updates on the Roadmap for Photocatalysis, ACS Catal. 10 (2020) 5493–5501. https://doi.org/10.1021/acscatal.0c01204. [2] S. Hao, X. Zhao, Q. Cheng, Y. Xing, W. Ma, X. Wang, G. Zhao, X. Xu, A Mini Review of the Preparation and Photocatalytic Properties of Two-Dimensional Materials, Frontiers in Chemistry. 8 (2020). https://www.frontiersin.org/articles/10.3389/fchem.2020.582146 (accessed August 19, 2022). [3] L. Chen, Y. Zhou, W. Tu, Z. Li, C. Bao, H. Dai, T. Yu, J. Liu, Z. Zou, Enhanced photovoltaic performance of a dye-sensitized solar cell using graphene–TiO 2 photoanode prepared by a novel in situ simultaneous reduction-hydrolysis technique, Nanoscale. 5 (2013) 3481–3485. https://doi.org/10.1039/C3NR34059G.