Regulation of Crystallization Kinetics, Morphology, and Mechanical Properties of Olefinic Blocky Copolymers

Zai-Zai Tong,Bing Zhou,Jie Huang,Jun-Ting Xu,Zhi-Qiang Fan

DOI: https://doi.org/10.1021/ma4023263

IF: 5.5

2014-01-01

Macromolecules

Abstract:Two olefinic blocky copolymers (OBCs) were quenched from different mixing states in the melt, and crystallization kinetics and morphology at various crystallization temperatures (T(c)s) and corresponding mechanical properties were studied. It is observed that, at lower T(c)s, premesophase separation in the melt accelerates crystallization of OBC-A with a weak segregation strength and a larger fraction of the crystalline hard blocks due to enrichment of the hard blocks in the hard-block-rich domains. By contrast, premesophase separation retards crystallization of OBC-B with a stronger segregation strength and lower fraction of the hard blocks because of the prevailing confinement effect at lower T(c)s. Moreover, since the hard blocks dissolved in the soft-block-rich domains can crystallize at lower T(c)s, which can bridge the crystals formed in different hard-block-rich domains, the crystal growth is not restricted. At higher T(c)s, OBC-A crystallizes more slowly from the premesophase-separated melt than that from the homogeneous melt, which is attributed to the weaker crystallizability of the hard blocks dissolved in the soft-block-rich domains and thus the restricted crystal growth. Nevertheless, mesophase separation always takes place prior to crystallization at higher T(c)s for OBC-B because of the faster rate of mesophase separation. Therefore, the mixing state in the melt has little effect on crystallization and morphology of OBC-B at higher T(c)s. It is found that the mechanical properties of OBCs can be regulated in a wide range by alteration of crystallization conditions. Better mechanical properties can be achieved when OBCs crystallize from the homogeneous melt and at a lower T-c.