Preparation Of Poly(L-Lactic Acid)-Modified Polypropylene Mesh And Its Antiadhesion In Experimental Abdominal Wall Defect Repair

Zhigang Zhang,Tianzhu Zhang,Junsheng Li,Zhenling Ji,Hemei Zhou,Xuefeng Zhou,Ning Gu
DOI: https://doi.org/10.1002/jbm.b.32947
2014-01-01
Abstract:A new type of polypropylene (PP) hernia mesh, modified with poly(l-lactic acid) (PLLA), was developed and used to repair rat abdominal wall defect. The PP mesh was first treated with oxygen plasma and then grafted with PLLA in phosphorus pentachloride (PCl5) solution in dichloride methane. The water contact angle changed during the procedure, and the coverage percentage of PLLA on the PP was about 80%. ATR-FTIR spectroscopy measurements showed the existence of carbonyl group absorption peak (1756.9 cm(-1)), and atomic force microscope and scanning electron microscope morphological observation indicated that the surface of the PP mesh was covered with PLLA graft. X-ray photoelectron spectroscopy spectra was used to probe chemical group changes and confirmed that the PLLA was grafted onto the PP. A total of 36 Sprague-Dawley rats were randomly divided into six groups, and they received either modified meshes (experimental groups) or PP meshes (control groups) to repair abdominal wall defects. All animals survived until the end of the experiment. Rats in each group were dissected after the operation (after 1 week, 2 weeks, and 1 month, respectively), and the adhesion effects were evaluated. Sections of the mesh parietal peritoneum overlap were examined histologically and graded for inflammation reaction. Compared with the control groups, the experimental groups showed a better ability to resist peritoneal cavity adhesions (P < 0.05), and there was no increase in inflammation formation (P > 0.05). This new type of PLLA-modified PP mesh displayed an additional property of antiadhesion in animal abdominal wall defect repair. (c) 2013 Wiley Periodicals, Inc. J Biomed Mater Res Part B: Appl Biomater, 102B: 12-21, 2014.
What problem does this paper attempt to address?