Abstract:Electrically-assisted forming has been proven to be an efficient process in terms of reducing forming flow stress, improving formability and supressing the springback for different hard-to-deform alloys. However, there is a controversial debate about whether the flow stress reduction with the introduction of electric current into a metallic specimen undergoing plastic deformation is attributed to Joule heat, additional athermal effect, namely the electroplasticity, or their combination thereof. There is a lack of thorough understanding of different mechanisms inducing the flow stress reduction and formability improvement, which would hinder the development and application of innovative electrically-assisted forming processes. Most prior works have examined only one or two materials with similar electroplastic behaviours, making it difficult to resolve this debate. In this study, three typical materials with diverse electroplastic behaviours, i.e. copper, SS304 and Ti6Al5V, were investigated and compared via electrically-assisted tensile tests and thermally-assisted tensile tests. The flow stress of the copper specimens in the electrically-assisted tensile test was lower than that in the thermally-assisted tensile test, which verifies the existence of electroplasticity. However, the flow stresses of the SS304 specimens in the electrically-assisted tensile test and thermally-assisted tensile test were similar at the same temperature, indicating that the athermal effect on the flow stress is not evident. For the Ti6Al4V specimens, the athermal stress reduction was not significant at lower current densities. However, the electrically-assisted and thermally-assisted tensile tests results began to differ when the current density exceeded 37.6 A/mm2. According to the further discussion on the microstructure evolution of different materials, the introduced current improves the dislocation motions and recovery and consequently reduces the flow stress in simple face-centered cubic structure materials such as copper. However, these effects can be suppressed by stronger effects such as the solution hardening in stainless steels. The current also affects the phase transition, which in turn influences the hardening behaviours of Ti6Al4V. By clarifying the cause of conflicting electroplastic effects, a uniform analytical method calculating the short- and long-range stresses that considers the correlation of electrical and thermal effects on dislocation motion, solution hardening and phase transformation was developed for electrically-assisted forming processes. The model was also experimentally verified.

Effects of Current Frequency on Electromagnetic Sheet Metal Forming Process

The importance of coil conductivity and eddy current effects in the analysis of electromagnetic forming process

Electromagnetic–Thermo–Mechanical Coupling Behavior of Cu/Si Layered Thin Plate under Pulsed Magnetic Field

Coil-less electromagnetic forming process with uniform-pressure characteristics for shaping sheet metals

Design and Experiments of Electromagnetic Heating Forming Technology

Dynamic Analysis of Closed Die Electromagnetic Sheet Metal Forming to Predict Deformation and Failure of AA6061-T6 Alloy Using a Fully Coupled Finite Element Model

Axially Movable Electromagnetic Forming System for Large-Scale Metallic Sheet

Effect of pulse width of middle-coil current on deformation behavior in electromagnetic tube forming under two-stage coils system

Empirical Modeling of Direct Electric Current Effect on Machining Cutting Force

Electromagnetic attractive forming of aluminum alloy sheets utilizing a low-frequency half-wave current

Electromagnetic forming of aluminum alloy sheet metal utilizing a low-frequency discharge: A new method for attractive forming

Effects of electrical pulse on metal deformation behaviors

Electroplasticity in electrically-assisted forming: Process phenomena, performances and modelling

Effect of induced pulse current on mechanical properties and microstructure of rolled 5052 aluminum alloy

Forming Limit and Mechanical Properties of 2024-O Aluminum Alloy Under Electromagnetic Forming

Deformation Mechanism of 5052 Aluminum Alloy Using Electrically Assisted Electromagnetic Forming

Toward better metal flow control in electrohydraulic sheet forming by combining with electromagnetic approach

Deformation behavior and formability of solid solution state Al–Li alloy in electromagnetic forming

Electromagnetic driven forming utilizing a metal ring for controlling shapes of sheet metals

Study on forming uniformity of multi-electromagnetic forming (EMF) of aluminum sheet metal