Abstract:Lithium-rich layered oxides have attracted much attention due to their high discharge capacity (>250 mA h·g–1). However, lithium-rich layered cathodes suffer from poor rate capabilities and voltage decay, which seriously limit their practical application. Herein, a unique @spinel double-spinel shell heterostructure is designed and successfully synthesized via coprecipitation and high-temperature solid-phase methods. In particular, lithium-rich layered oxides show good rate capabilities and high capacity retention when the molar amount of cobalt acetate and manganese acetate is 5%. After 100 cycles at 0.2 C, a discharge capacity of 232 mA h g–1 and a capacity retention of 92.7% can be obtained. The superior electrochemical performance of the in situ-transformed Li-rich layered cathode can be attributed to the unique three-dimensional diffusion channels for Li ions of the surface spinel phase. Besides, the in situ-transformed LiCoMnO4 shell can also improve the structural stability of the Li-rich layered oxides by reducing the side reactions and protecting the material from being corroded by the electrolyte. This study provides a strategy for surface modification, which can effectively improve the electrochemical performance of Li-rich layered cathode materials with high performance.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsaem.1c01955.SEM image of the precursor Ni1/6Co1/6Mn4/6CO3 and the corresponding mapping spectrum; ex situ XRD spectra of the LLO and LSS-0.05 samples; EDS line scan of the selected area and the corresponding HTEM diagram of the LSS-0.05 sample; CV and dQ/dV curves of the first three cycles of the LLO, LSS-0.05, and LSS-0.1 samples; initial charge and discharge curves of LiCoMnO4, LSS-0.2, and LSS-0.4 samples; discharge curves of LLO, LSS-0.05, and LSS-0.1 samples at different rates and with different cycles; typical single titration curve of GITT measurements; equivalent circuit of half-cells; and EIS spectra of LLO, LSS-0.05, and LSS-0.1 samples in the initial cycle (PDF)This article has not yet been cited by other publications.

Improving the Electrochemical Performance of Layered Lithium-Rich Transition-Metal Oxides by Controlling the Structural Defects

Stacking Fault Disorder Induced by Mn Doping in Ni(OH)2 for Supercapacitor Electrodes

Improvement of stability and capacity of Co-free, Li-rich layered oxide Li1.2Ni0.2Mn0.6O2 cathode material through defect control

Cooperative Structure of Li/Ni Mixing and Stacking Faults for Achieving High-Capacity Co-free Li-rich Oxides

Stacking‐Fault Enhanced Oxygen Redox in Li2MnO3

Mitigating Evolution of Lattice Oxygen and Stabilizing Structure of Lithium-Rich Oxides by Fabricating Surface Oxygen Defects

Improving electrochemical performance of NCM811 cathodes for lithium-ion batteries via consistently arranging the hexagonal nanosheets with exposed {104} facets

Improving the Electrochemical Performance of Layered Li-Rich Transition-Metal Oxides by Alleviating the Blockade Effect of Surface Lithium

Stacking Faults Hinder Lithium Insertion in Li 2 RuO 3

Regulation of 3d‐Transition Metal Interlayered Disorder by Appropriate Lithium Depletion for Li‐Rich Layered Oxide with Remarkably Enhanced Initial Coulombic Efficiency and Stability

Improving the Electrochemical Performance of a Lithium-Rich Layered Cathode with an In Situ Transformed Layered@Spinel@Spinel Heterostructure

Enhanced Li-ion Intercalation Kinetics and Lattice Oxygen Stability in Single-Crystalline Ni-rich Co-poor Layered Cathodes

In-situ formation of Li0.5Mn0.5O coating layer through defect controlling for high performance Li-rich manganese-based cathode material

Constructing uniform oxygen defect engineering on primary particle level for high-stability lithium-rich cathode materials

Electrochemical Performance of Layer-Structured Ni0.8Co0.1Mn0.1O2 Cathode Active Materials Synthesized by Carbonate Co-Precipitation

Electrochemical Performances of Layered LiNi0.7CO0.3–xMxO2 (m=al, Mn, Cr; X=0.05) Cathode Materials for Rechargeable Lithium Batteries

Stacking Faults Hinder Lithium Insertion in Li<sub>2</sub>RuO<sub>3</sub>

Fundamental Mechanism Revealed for Lithium Deficiencies Engineering in a Spherical Li-Rich Mn-Based Layered Li <sub>1.23</sub>mn <sub>0.46</sub>ni <sub>0.246</sub>co <sub>0.046</sub>al <sub>0.015</sub>o <sub>2</sub> Cathode

Optimizing conditions and improved electrochemical performance of layered LiNi1/3Co1/3Mn1/3O2 cathode material for Li-ion batteries

Annealing Modulation Defect Chemistry toward High-Performance Sodium-Layered Cathodes

Electrochemical Kinetics And Performance Of Layered Composite Cathode Material Li[Li0.2ni0.2mn0.6]O-2