Abstract:Very high energy deposition on first wall and other components of a fusion reactor la expected due to plasma instabilities during both normal and off-normal operating conditions. Off-normal operating conditions result from plasma disruptions where the plasma loses confinement and dumps its energy on the reactor components. High heat flux may also result froa normal operating conditions due to fluctuations in plasma edge conditions. This high energy dump In a short time results In very high surface temperatures and may consequently cause melting and vaporization of these materials. The net erosion rates resulting froa melting and vaporization are very important to estimate the lifetime of such Components. The response of different candidate materials to this high heat fluxes is determined for different energy densities and deposition times. The analysis used a previously developed model to solve the heat conduction equation in two moving boundaries. One moving boundary is at the surface to account for surface recession due to vaporization and the second moving boundary is to account for the solid-liquid interface inside the material. The calculations are done parametrlcally for both the expected energy deposited and the deposition time. These ranges of energy and tine are based on recent experimental observations in current fusion devices. The candidate materials analyzed are stainless steel, carbon, and tungsten. INTRODUCTION Very high heat fluxes on the plasma chamber wall, on limiters/divertor plates and on other components of a fusion reactor are expected during both normal and off• Work supported by the U.S. Department of Energy under contract No. W-31-1O9-Eng-38. normal operating conditions. Off-normal operating conditions can result from unipolar arcing, run-away electrons, and plasma energy dump following a disruption event. High energy deposition may also result during normal operating conditions because of fluctuations in plasma edge conditions recently known as edge localized modes (ELKS). The energy deposited on these components ; during auch «v«nts can be in the order of several hundred megaJoules. This high energy deposition time is i recently believed to be much less than 1 ms. As a result, the energy on the high heat flux components may reach values up to 10,000 KU/cm or even higher. Severe melting and vaporization of the reactor components may then occur. It Is then important to accurately evaluate the amount of material evaporated and melted from the exposed surfaces at these short deposition times. The evaporated material may contaminate the plasma with a hlgh-Z material such as tungsten. But more seriously, both evaporation and melting will contribute to the first uall, limiter, and dlvertor plate erosion which consequently limits the lifetime of these components and hence the availability of the reactor. Hecent modeling efforts (1-6) have focused on the analysis and on the development of computer codes to quantify the effects of the high energy dump on reactor materials. The analysis presented here used a previously developed model to solve the heat conduction equation with nonlinear boundary conditions (1). In this model the surface temperature is determined by both the boundary conditions as well as by the kinetics of the evaporation process. The kinetics of the evaporation :establish the connection between the surface temperature and the net atom flux leaving the surface taking into account the possibility of recondensation. Consequently, this heat conduction problem is highly non-linear and involves two moving boundaries. One moving boundary is at the melt-solid interface, while the other i3 due to the surface receding as a result of the vaporization losses. Several Improvements in calculational methods have recently been incorporated into the analysis. These include advanced numerical methods for more accurate temperature calculation in moving boundaries problems. Both finite difference and finite element methods have been used efficiently to solve this 3ystem of equations, and consistent results were obtained £62. Improved analytical expressions for thermophysical properties are used to provide a better fit over a wider temperature range. Numerical results are given for candidate materials such as stainless steel, carbon, and tungsten. These results are given parametrically in terms of the deposition times and energy densities. Short disruption times recently suggested may cause severe erosion rates and may limit reactor component lifetime. Several experiments have recently been carried out using an electron beam test facility to Investigate the consequences of simulated plasma disruption (7-10)• The general conclusions from these experiments have indicated a fairly good agreement between the models and the calculations described in this paper and the measured values for the melt layer and vaporization thicknesses.

Constitutive Activation Of Nuclear Factor Kappa B Contributes To Cystic Fibrosis Transmembrane Conductance Regulator Expression And Promotes Human Cervical Cancer Progression And Poor Prognosis

An Experimental Research on Effect of LTβR and P65 in Progression of Bladder Cancer

High Expression of Stromal Cell-Derived Factor 1 (SDF-1) and NF-κB Predicts Poor Prognosis in Cervical Cancer

Expression of Nuclear Factor-κB and Its Clinical Significance in Nonsmall-Cell Lung Cancer

NF-κB Over-Activation Portends Improved Outcomes in HPV-associated Head and Neck Cancer.

Expression of Telomeric Repeat Binding Factor 1 in Non-Small Cell Lung Cancer.

Significance of PTPRZ1 and CIN85 expression in cervical carcinoma

Relationship between vascular endothelial growth factor and nuclear factor-kappaB in renal cell tumors

RESPONSE OF MATERIALS TO SEVERE HEAT FLUXES DURING OPERATION IN FUSION REACTORS

Defective CFTR- β-catenin interaction promotes NF-κB nuclear translocation and intestinal inflammation in cystic fibrosis

Inhibition of Experimental Nephrocalcinosis by Hypophysectomy.∗

[Expression of NF-E1b in Colorectal Cancer Tissues and Its Clinical Significance].

CCL3 Promotes Proliferation of Colorectal Cancer

Data from the Biphasic Role of NF-κB in Progression and Chemoresistance of Ovarian Cancer

The role of NF-κB in carcinogenesis of cervical cancer: opportunities and challenges

CCL3 Promotes Proliferation of Colorectal Cancer Related with TRAF6/NF-κB Molecular Pathway

Abstract 3389: Nuclear Accumulation of C-Rel Transcription Factor is Correlated with the Proteasome Inhibitor Resistance in Mantle Cell Lymphoma.

The role of NFATc1/c-myc/PKM2/IL-10 axis in activating cervical cancer tumor-associated M2 macrophage polarization to promote cervical cancer progression

ZNF281 Facilitates the Invasion of Cervical Cancer Cell Both In Vivo and In Vitro †

The role of PKM2 nuclear translocation in the constant activation of the NF-κB signaling pathway in cancer-associated fibroblasts

Study on the effect and mechanism of NFKBIA on cervical cancer progress in vitro and in vivo