Three-dimensional finite element analysis of the stress distribution of condylar cartilage during mandibular distraction osteogenesis in goats
Jie Long,Yu-bo Fan,Wei-dong Tian,Ling Wu,Xiao-hui Zheng
DOI: https://doi.org/10.3321/j.issn:1673-8225.2006.37.044
2006-01-01
Abstract:Aim: To analyze the stress distribution of the condylar cartilage during mandibular distraction osteogenesis in goats. Methods: The experiment was performed at the Key lab of Biomechanics, Sichuan University and Animal Operation Center, West China Stomatology Hospital ,Sichuan University from January to December 2005. Corticotomy was performed in right side mandible of 1 goat, distraction force exerting for 4 times daily, distraction frequency was 0.2 mm/ 6 hours, distraction rate was 0.8 mm/day, distraction period was 12 days, and then entering the consolidation period. The animal was sacrificed at 4th week after distraction, CT scaning was done to the craniofacial bone with SIMENS SOMATOM 16 spiral CT, the 3D finite element model was established by the Mimics software, and then the stress distribution of the condylar cartilage was analyzed by Patran software. Results: (1) The value of Von Mises stress on the surface of the condylar cartilage of the distraction side was higher than that of the other side [Von Mises stress of distraction side / Von Mises stress of the other side: 14.6/0.92 in anterior-internal slope of condylar cartilage, 2.3/0.17 in anterior-middle slope of condylar cartilage, 4.5/ 0.9 in posterior-external slope of condylar cartilage, 5.7/0.6 in interal 1/3 of transverse ridge of condylar cartilage, 2.6/0.8 in middle 1/3 of transverse ridge of condylar cartilage, 1.8/0.11 in external 1/3 of transverse ridge of condylar cartilage, 1.7/1.1 in posterior-internal slope of condylar cartilage, 0.9/0.2 in posterio-middle slope of condylar cartilage, 1.4/0.3 in posterior-external slope of condylar cartilage]; (2)The anterior slope of condyle was the most pressed area, but the transverse ridge area and posterior slope area were most pulled area; (3)In the observation of sagital direction, it showed that mean value of Von Mises stress on the surface of anterior slope was the maximum, followed by transverse ridge area and that was the minimal at posterior slope; In the observation of coronal direction, the mean value of Von Mises stress was larger in the internal area than the middle and external area. Conclusion: The distraction force will lead to some stress distribution on the surface of condylar cartilage during distraction osteogenesis, and the stress would make some changes in the TMJ (temporomandibular joint).