Abstract:A digital deconvolution method with pile-up reconstruction has been proposed for scintillator detectors for high rate photon-counting X-ray imaging applications. The detector signal was modeled as an exponential decay waveform convoluted with the single photon response of the SiPM detector. An impulse signal can be obtained by digital deconvolution (unfolding) with much shorter duration, which was then used for energy estimation followed by a trapezoid filter and pile-up discrimination The whole digital deconvolution algorithm has been synthesized and verified by both SIMULINK simulation and experimental tests. The prototype of the detector and the readout electronics were developed for demonstration, using 3 mm x 3 mm x 10 mm LYSO scintillator coupled with a 3 mm x 3 mm SenSL SiPM. A 14 bit, 100 MSPS ADC was used to sample the analog waveform and the digital filter was implemented in a Xilinx Kintex 7 FPGA. The signal width was shortened from similar to 250 ns to 10 similar to 20 ns and then was shaped into trapezoidal pulse with 100 ns width. The energy was estimated from the trapezoid top for better signal collection and noise rejection. The unfolded pulses were used for pile-up discrimination and to reconstruct two pile-up signals from the overlapped trapezoid outputs. The energy performance of the prototype system was firstly validated by measuring the energy spectrums of Am-241, Co-57, Na-22 and Cs-137 radiation sources. The energy resolutions were measured to be 36.9%, 29.9%, 13.9% and 12.9% respectively at 59.5 keV, 122 keV, 511 keV and 662 keV in FWHM. High rate performance was evaluated by an X-ray generator. The maximum output counting rate was measured to 5.36 Mcps without saturation, comparing with the saturated counting rate of 2.34 Mcps using the original LYSO signals The saturation counting rate using digital deconvolution was estimated to be up to similar to 7 Mcps fitted with the paralyzable dead time model, corresponding to similar to 20 Mcps input count rate.

Scintillation Event Energy Measurement Via a Pulse Model Based Iterative Deconvolution Method

A deconvolution based signal reconstruction capable of piled-up pulse separation

Digital Deconvolution Of Scintillation Detector Signals For High Rate Photon-Counting X-Ray Imaging Applications

Advantages of Digitally Sampling Scintillation Pulses in Pileup Processing in Pet

Empirical Bayesian Energy Estimation for Multi-Voltage Threshold Digitizer in Pet

A Preliminary Experimental Valiadation of A New Approach for Pulse Processing in Pet

Energy Calibration Method for an All-Digital High Resolution Gamma-Ray Spectroscopy

Event Pulse Classification with Multi-Voltage Threshold Samples for Scatter Rejection in PET

Investigation of Digitally Sampling Scintillation Pulses in Energy Determination in PET

Characterization of LSO/PMT Scintillation Pulses

Evaluation of Signal Energy Calculation Methods for A Light-Sharing Sipm-Based Pet Detector

Investigation and optimization of the deconvolution method for PMT waveform reconstruction

Scintillator-SiPM Detector for Tracking and Energy Deposition Measurements

An MVT based all-digital DAQ for energy determination

Improving Photoelectron Counting and Particle Identification in Scintillation Detectors with Bayesian Techniques

Generalized Method for the Optimization of Pulse Shape Discrimination Parameters

Compton Edge Convolutional Model and Algorithm for Energy-channel Calibration

Potentials of Digitally Sampling Scintillation Pulses in Timing Determination in Pet

Machine-Learning based photon counting for PMT waveforms and its application to the improvement of the energy resolution in large liquid scintillator detectors

Timepix3: single-pixel multi-hit energy-measurement behavior

Near threshold pulse shape discrimination techniques in scintillating CsI(Tl) crystals