Abstract:The performance of vertical and horizontal wells is usually evaluated using water level wells or piezometers in landfills. In this study, pumping tests in vertical and horizontal wells were performed at the Changan and Tianziling landfills, respectively. During the pumping tests, the leachate level drawdown around the wells and the resistivity of the surrounding waste were both measured to investigate the feasibility of applying electrical resistivity tomography (ERT) to monitor the dewatering in landfills. It was found that the resistivity rho of the waste samples drilled from the Tianziling landfill decreased as volumetric moisture content theta increased, and the relationship could be fitted with Archie's law (rho = rho(w)a theta(-m)). For waste samples with the same theta, rho tended to increase as the depth of the samples increased. It was because the waste at deeper layers experienced longer degradation and tended to have greater proportion of inert particles like cinder and dust. During a vertical well pumping test in the Changan landfill, the resistivity of waste on the right side of the well increased by 10% to 30%. The distribution of areas where resistivity increased was heterogeneous. During two horizontal well pumping tests in the Tianziling landfill, the areas where resistivity increased were distributed in an ellipse around one well and were horizontally distributed around another well. The resistivity of waste near the two wells increased by 4% to 18%. According to the ERT testing results, the influence radii of the two wells were estimated as 38.7 m and 33.2 m, respectively. These were close to the values (i.e., 42.1 m and 34.8 m, respectively) obtained through leachate level testing results. Artifacts produced by the inversion process were both found in the ERT images of vertical and horizontal well pumping tests. The combined use of ERT with other hydrogeological monitoring methods can improve the understanding of draining effects by vertical and horizontal wells in landfills.

Study on gas migration around vertical extraction wells in municipal solid waste landfills

A model for gas pressure in layered landfills with horizontal gas collection systems

A Gas Flow Model for Layered Landfills with Vertical Extraction Wells.

Influences of Leachate Level on Landfill Gas Collection

Axisymmetric Gas Flow Model for Bioreactor Landfills Incorporating MSW Compression and Leachate Recirculation

Factors affecting gas closure capacity of enhanced gas collection cover and optimized arrangement

Analytical Solution of Leachate Flow to Vertical Wells in Municipal Solid Waste Landfills Using a Dual-Porosity Model

Application of Electrical Resistivity Tomography to Monitor the Dewatering of Vertical and Horizontal Wells in Municipal Solid Waste Landfills

One-dimensional Transient Solution for Landfill Gas Pressure in Landfills

One-dimensional Gas Migration in Multi-Layered Landfills of Municipal Solid Wastes

Vertical Expansion Stability of an Existing Landfill: A Case Study of a Landfill in Xi’an, China

One-dimensional Steady-state Model for Gas Pressure Distribution in Municipal Solid Waste Landfills

A Dual-Porosity Model for Coupled Leachate and Gas Flow to Vertical Wells in Municipal Solid Waste Landfills

Improvement of Vacuum Pressure on Pumping Performance of Vertical Wells in Municipal Solid Waste Landfills.

A Bio-Hydro-chemical Model for Gas Pressure Development in Municipal Solid Waste Landfills

Modeling of Leachate Recirculation Using Vertical Wells in Bioreactor Landfills

One-Dimensional Transient Analytical Solution for Gas Pressure in Municipal Solid Waste Landfills

Field investigation and numerical modelling of gas extraction in a heterogeneous landfill with high leachate level

Numerical Simulation of the Radius of Influence for Landfill Gas Wells

Modelling of Effects of Water Vapor and Temperature Gradient on Moisture and Gas Transfer in Unsaturated Landfill Cover

Simulation Of The Effective Distance In Horizontal Direction From Vertical Well In Landfill