Testing and analysis of the load distribution among bearings in a 600 MW steam turbine unit

Yanyong Li,Chuan Dong,Jiangang Yang,Shidong Zhang

2013-01-01

Abstract:Established was a mathematical model for solving the load distribution among bearings in a steam turbine. A group of strain gauges was arranged at both sides of the couplings of the turbine rotor and the whole bridge mode was adopted to measure and test the bending strain values at multiple sections of the rotor, thus obtaining the loads on bearings by using the strain values actually measured. The method in question was used to develop a strain system for testing the loads on bearings of a steam turbine. An experimental study was performed of a 600 MW steam turbine unit and the loads distribution among bearings of a high pressure rotor and two low pressure rotors were obtained with the alignment of the shafting system of the unit being analyzed. The test results show that the method under discussion can be used to conveniently and accurately identify the load and center distribution of bearings, thus offering guidance for installation and maintenance of the unit.