Self-assembled microlens array with controllable curvatures for integral imaging 3D display
Miao Xu,Jing Li,Xueying Chang,Cuifen Chen,Hongbo Lu,Zi Wang
DOI: https://doi.org/10.1016/j.optlaseng.2024.108322
IF: 5.666
2024-05-18
Optics and Lasers in Engineering
Abstract:A crucial requirement for integral imaging 3D displays is the development of a straightforward, rapid, and cost-effective method for fabricating a microlens array (MLA) with uniform sizes, controllable curvatures, and apertures over a large area. This paper introduces the use of a wettability-guided dip-coating method to prepare the MLA. Initially, the substrate undergoes coating with a discontinuous hydrophobic layer, complemented by a hydrophilic microhole array pattern. When an optical fluid-silicon oil, flows across the substrate surface, it selectively adheres to hydrophilic areas, forming microdroplets through surface tension. These microdroplets can serve as microlenses with commendable optical performance. A detailed examination was conducted to elucidate the regulatory principles influencing microlens morphology in relation to liquid viscosity and lifting speed. A well-designed MLA, confined within a square measuring 3.5 cm × 4 cm, showcases microlenses with an 800 μm diameter, a circular center distance of 850 μm, and a focal length of 3.5 mm. When integrated with a 2D elemental image array, this configuration yields a lateral viewing range of 11.33 cm at a viewing distance of 65 cm. The proposed method for preparing the MLA offers advantages such as uniform size, controllable curvature, and a smooth surface, thereby facilitating the industrialization of MLA for integrated imaging 3D displays.
optics