Abstract:Compressible flow past a circular cylinder at an inflow Reynolds number of 2 x 10 5 is numerically investigated by using a constrained large-eddy simulation (CLES) technique. Numerical simulation with adiabatic wall boundary condition and at a free-stream Mach number of 0.75 is conducted to validate and verify the performance of the present CLES method in predicting separated flows. Some typical and characteristic physical quantities, such as the drag coefficient, the root-mean-square lift fluctuations, the Strouhal number, the pressure and skin friction distributions around the cylinder, etc. are calculated and compared with previously reported experimental data, finer-grid large-eddy simulation (LES) data and those obtained in the present LES and detached-eddy simulation (DES) on coarse grids. It turns out that CLES is superior to DES in predicting such separated flow and that CLES can mimic the intricate shock wave dynamics quite well. Then, the effects of Mach number on the flow patterns and parameters such as the pressure, skin friction and drag coefficients, and the cylinder surface temperature are studied, with Mach number varying from 0.1 to 0.95. Non-monotonic behaviors of the pressure and skin friction distributions are observed with increasing Mach number and the minimum mean separation angle occurs at a subcritical Mach number of between 0.3 and 0.5. Additionally, the wall temperature effects on the thermodynamic and aerodynamic quantities are explored in a series of simulations using isothermal wall boundary conditions at three different wall temperatures. It is found that the flow separates earlier from the cylinder surface with a longer recirculation length in the wake and a higher pressure coefficient at the rear stagnation point for higher wall temperature. Moreover, the influences of different thermal wall boundary conditions on the flow field are gradually magnified from the front stagnation point to the rear stagnation point. Moreover, the influences of different thermal wall boundary conditions on the flow field are graduallymagnified from the front stagnation point to the rear stagnation point. It is inferred that the CLES approach in its current version is a useful and effective tool for simulating wall-bounded compressible turbulent flows with massive separations.

Large Eddy Simulation of Flow Past Circular Cylinder Based on the Least Square Meshless Method

Constrained Large-Eddy Simulation of Compressible Flow Past a Circular Cylinder

Application of Large Eddy Simulation to an Oscillating Flow Past A Circular Cylinder

A LARGE EDDY SIMULATION OF THE NEAR WAKE OF A CIRCULAR CYLINDER

Large eddy simulating based on least square meshless method

Constrained Large Eddy Simulation of Wall-Bounded Turbulent Flows

Large eddy simulation of flows around a square cylinder

New Insight on Large-Eddy Simulation of Flow Past a Circular Cylinder at Subcritical Reynolds Number 3900

Large-eddy simulation of the flow past a cylinder with Re=3 900

Large Eddy Simulation of Flow Past a Square Cylinder Based on Dynamic Sub-Grid Scale Models

Large-Eddy Simulation of the Flow Past Both Finite and Infinite Circular Cylinders at Re=3900

Large Eddy Simulation of 3-Dimensional Incompressible Flow Around a Square Cylinder

Numerical Study of Flow Characteristics Around Square Cylinder at High Reynolds Number

Large Eddy Simulation of Wake Formation Around a Free Surface–Piercing Circular Cylinder

Numerical investigation of the flow behavior around a single cylinder using Large Eddy Simulation model

Three-dimensional Numerical Simulation of the Flow Past a Circular Cylinder Based on LES Method

Large Eddy Simulation Research on Hydrodynamic Characteristic of Flow around Cylinder

3-Dimensional large eddy simulation of circular cylinder at Re=3 900

Large-eddy simulations of flow past a circular cylinder near a free surface

Adaptive Mesh Refinement Method-Based Large Eddy Simulation for the Flow over Circular Cylinder at ReD = 3900