Abstract:In this paper, electro-Fenton and sulfate radical-based electro-Fenton-like processes were used to degrade artificial sweeteners and azo dye. The results obtained during the research concern the removal efficiency, the oxidation mechanism, degradation pathway and toxicity evolution of target pollutants.(1) Electro-Fenton process was a effective method for the degradation of ASP in water. The removal and mineralization rate was affected by the Fe2+ concentration and applied current. The absolute rate constant of hydroxylation reaction of ASP was (5.23 ± 0.02) × 109 M–1 S–1. Short-chain aliphatic acids such as oxalic, oxamic and maleic acid were identified as aliphatic intermediates in the electro-Fenton process. The bacteria luminescence inhibition showed the toxicity of ASP solution decreased after it reached a maximum during the first period of the oxidation reaction.(2) Artificial sweetener SAC could be degraded effectively by electro-Fenton process with a DSA, Pt or BDD anode. However, the using of BDD anode could accelerate the mineralization of SAC. The optimal conditions for SAC removal were SAC concentration 0.2 mM, Fe2+ concentration 0.2 mM, Na2SO4 concentration 50 mM, applied current 200 mA and initial pH 3.0. Oxalic, formic, and maleic acid were observed as aliphatic byproducts of SAC during electro-Fenton process. The bacteria luminescence inhibition showed the toxicity of SAC solution increased at the beginning of electrolysis, and then it declined until the end of the reaction.(3) Artificial sweetener Sucralose could be completely mineralized in a 360 min reaction by electro-Fenton process with a Pt or BDD anode. The mineralization rate was affected by the Fe2+ concentration and applied current. The mineralization current efficiency (MCE) decreased with rising applied current from 100 to 500 mA with both Pt and BDD anode. Oxalic, pyruvic, formic and glycolic acids were detected during the oxidation of sucralose.(4) Orange II was effectively decolorized by EC/α-FeOOH/PDS process. The initial pH of Orange II solution had little effect on the decolorization of Orange II. RSM based on Box-Behnken statistical experiment design was applied to analyze the experimental variables. The response surface methodology models were derived based on the results of the pseudo-first-order decolorization rate constant and the response surface plots were developed accordingly. The results indicated the applied current showed a positive effect on the decolorization rate constant of Orange II. The interaction of α-FeOOH dosage and PDS concentration was significant. The ANOVA results confirmed that the proposed models were accurate and reiable for the analysis of the varibles of EC/α-FeOOH/PDS process. The catalystα-FeOOH showed good structural stability and could be reused.(5) Aqueous solutions of Orange II have been degraded effectively in the EC/Fe3O4/PDS process. The decolorization rate was affected by the initial pH of Orange II solution, current density, PDS concentration and Fe3O4 dosage. Orange II can be totally decolorizated in a 60 min reaction when initial Orange II concentration was 25 mg/L, PDS concentration was 10 mM, Fe3O4 dosage was 0.8 g/L, current density was 8.4 mA/cm2 and initial pH was 6.0. Recycle experiments showed Fe3O4 particles were stable and can be reused. XPS spectrum indicated Fe(II) was generated on the surface of Fe3O4 particles after reaction. The main intermediates were separated and identified by GC-MS technique and a plausible degradation pathway of Orange II was proposed

Decolorization of orange II in water induced by Ferrous/sulfite system at near neutral pH values

Decolorization of an Azo Dye Orange G in Aqueous Solution by Fenton Oxidation Process: Effect of System Parameters and Kinetic Study

A Novel Fenton-like System of Fe2O3 and NaHSO3 for Orange II Degradation

Photodegradation of Orange Ii Using Waste Paper Sludge-Derived Heterogeneous Catalyst in the Presence of Oxalate under Ultraviolet Light Emitting Diode Irradiation

Degradation of organic dye wastewater using polycarboxylic acid modified SR-Photo-Fenton

Removal of Organic Pollutants from Water by Electro-Fenton and Electro-Fenton Like Processes

Degradation of Acid Orange 7 in aqueous solution by a novel electro/Fe2+/peroxydisulfate process

Enhanced degradation of Orange II using a novel UV/persulfate/sulfite system

DECOLORIZATION OF ACID ORANGE Ⅱ BY Fe AND Mn SPECIES IN THE PRESENCE OF ULTRAVIOLET IRRADIATION

A Triple System of Fe(III)/sulfite/persulfate: Decolorization and Mineralization of Reactive Brilliant Red X-3B in Aqueous Solution at Near-Neutral Ph Values

Strong degradation of orange II by activation of peroxymonosulfate using combination of ferrous ion and zero-valent copper

Ph-Dependent Degradation of Acid Orange II by Zero-Valent Iron in Presence of Oxygen

Removal of Orange II Using an Adsorbent-Supported Zero-Valent Iron As a Heterogeneous Fenton-like Catalyst

Influence of Chloride Ions on Organic Contaminants Decolorization Through the Fe0-activated Persulfate Oxidation Process: Efficiency and Intermediates.

Strategies comparison of eliminating the passivation of non-aromatic intermediates in degradation of Orange II by Fe3+/H2O2.

Fe(III)/H2O2-Like System for Removal of Azo Dye from Aqueous Solution

Decolorization and Mineralization of Acid Orange Ⅱ by NaClO Oxidation

Kinetics of Reductive Degradation of Orange II in Aqueous Solution by Zero‐valent Iron

Degradation mechanism of acid orange II in persulfate/Fe-based metallic glass system

Decolorization of Azo Dyes in a Heterogeneous Persulfate System Using FeS As the Activator.

Improved degradation of Orange II by Fe<sub>3</sub>O<sub>4</sub>/NiO/NaHSO<sub>3</sub> system under visible light irradiation