Dynamic load identification for an ejector tube

NIE Jun-feng,LU Qiu-hai,ZHANG Hai-quan,YOU Xiao-chuan,ZHUANG Zhuo
DOI: https://doi.org/10.3969/j.issn.1000-3835.2013.18.031
2013-01-01
Abstract:Dynamic load identification of an ejector tube in processing of an engine testing was studied based on the frequency domain identification method.The dynamic response of the ejector tube in the processing of the engine testing was measured.Then,the response of the structure to the basis function of load was gained with FEM.Finally,the dynamic load spectrum of the ejector tube was obtained with the least squares method.The dynamic response of the ejector tube to the identified dynamic load spectrum was calculated and compared with that of the ejector tube in the engine testing measured.The error of the identified dynamic load spectrum was given and the cause of the error was analyzed.The results showed that the proposed identification method can be used to identify the dynamic load of the ejector tube in processing of an engine testing accurately,and the study results can provide a reference for further engineering studies.
What problem does this paper attempt to address?