Abstract:Estimation of the stress distribution in ferromagnetic components is very important for evaluating the working status of mechanical equipment and implementing preventive maintenance. Eddy current testing technology is a promising method in this field because of its advantages of safety, no need of coupling agent, etc. In order to reduce the cost of eddy current stress measurement system, and obtain the stress distribution in ferromagnetic materials without scanning, a low cost eddy current stress measurement system based on Archimedes spiral planar coil was established, and a method based on BP neural network to obtain the stress distribution using the stress of several discrete test points was proposed. To verify the performance of the developed test system and the validity of the proposed method, experiment was implemented using structural steel (Q235) specimens. Standard curves of sensors at each test point were achieved, the calibrated data were used to establish the BP neural network model for approximating the stress variation on the specimen surface, and the stress distribution curve of the specimen was obtained by interpolating with the established model. The results show that there is a good linear relationship between the change of signal modulus and the stress in most elastic range of the specimen, and the established system can detect the change in stress with a theoretical average sensitivity of -0.4228 mV/MPa. The obtained stress distribution curve is well consonant with the theoretical analysis result. At last, possible causes and improving methods of problems appeared in the results were discussed. This research has important significance for reducing the cost of eddy current stress measurement system, and advancing the engineering application of eddy current stress testing.

Stratified analysis of the magnetic Barkhausen noise signal based on wavelet decomposition and back propagation neural network

Stratified Analysis of the Magnetic Barkhausen Noise Signal Based on Wavelet Decomposition and Back Propagation Neural Network

An application of back propagation neural network for the steel stress detection based on Barkhausen noise theory

Unsteady Fault Diagnosis Based on Wavelet-Networks

Method of measuring the stress of ferromagnetic materials based on EMAT and magnetic Barkhausen noise characteristic parameters

Stress Distribution of Q2 3 5 in Different Depth Using Magnetic Barkhausen Noise Technique

The Application of Shuffled Frog Leaping Algorithm to Wavelet Neural Networks for Acoustic Emission Source Location

Barkhausen Noise Application in the Detection of Stress and Fatigue Damage

Influence of Defects on Stress Detection by Magnetic Barkhausen Noise

Investigation of temperature effect of stress detection based on Barkhausen noise

Quantitative evaluation of residual stress and surface hardness in deep drawn parts based on magnetic Barkhausen noise technology

Research on Stress Detection of DC01 Steel via Barkhausen Noise

The application of wavelet shrinkage denoising to magnetic Barkhausen noise measurements

The effect of DC magnetic field on signal characteristics of magnetic Barkhausen noise

Low-frequency environmental magnetic noise elimination based on a neural network algorithm for TMR sensor arrays

Estimation of stress distribution in ferromagnetic tensile specimens using low cost eddy current stress measurement system and BP neural network

Effect of stress on the magnetic Barkhausen noise energy cycles: A route for stress evaluation in ferromagnetic materials

Stress measurement using magnetic Barkhausen noise and metal magnetic memory testing

A theoretical simulation for MBN testing: Modeling microscopic local magnetization jumps in magnetic domain movement

A Survey of the Magnetic Anisotropy Detection Technology of Ferromagnetic Materials Based on Magnetic Barkhausen Noise

Fault Diagnosis Method for the Rolling Bearing of Railway Vehicle Based on Wavelet Packet Transform and BP Neural Network