Abstract:The morphological characteristics of the gas-liquid interfaces receding through the gap with a sharp feature in a quasi-static fashion is investigated in this paper. A series of quasi-static experiments have been performed. A theoretical model that tracks the movement of the gas-liquid interface is developed. Different from previous models, our model is developed on the mesoscopic scale and the pressure difference at every point on the interface is different because the effect of gravity cannot be ignored. A method to solve numerically the model under specific boundary conditions is proposed. The numerical result is experimentally verified, and good agreement is found between predicted and experimental behaviors of the gas-liquid interface. Through this model, the following analysis is carried out. Firstly, threshold of the model application was determined. Then, numerical results of residual liquid were obtained. It is concluded that the critical curve that determines whether liquid remains or not is independent of the receding contact angle when the gap is small (below 0.5 mm), while it is related to the receding contact angle when the gap is large (above 0.5 mm). Finally, it was carried out to understand the evolution of pressure difference and determine the maximum pressure difference. It is found that the maximum pressure difference appears at the first corner of the feature. The maximum pressure difference decreases with the increase of the gap height and decreases with the increase of the receding contact angle. This allows us to effectively design and optimize the removal structure in the immersion head. This model not only applies to the rectangular feature in this paper, but also to arbitrary features, and even to track advancing the gas-liquid interface using the advancing contact angle.

Shape characteristics of gas screen of underwater vehicle vertical launch

Study on characteristics of gas–liquid two-phase flow in pump as turbine using multiple-size group model

Three-Dimensional Numerical Simulation of Air Exhausted from Submerged Nozzles

Numerical Simulation on Field Characteristics of the Horizontal Gas Jet Flow of Underwater Vehicle

The Research on High-Speed Gas Jet of Rocket Nozzle Underwater

Study on flow field of underwater low-speed gas jet

Numerical Investigation of Microbubble Drag Reduction on an Axisymmetric Body Based on Eulerian Multiphase Model

Morphological Characteristics of Gas-Liquid Interfaces Receding Through the Mesoscopic Gap with a Sharp Feature

Experimental investigation of cavity stability for a gas-jet penetrating into a liquid sheet

Experimental Study on Gas-Liquid Flow Characteristics of Submerged Air Jets

Numerical Study on the Effect of a Lobed Nozzle on the Flow Characteristics of Submerged Exhaust

Experimental Study and Numerical Simulation of the Characteristics of a Percussive Gas–solid Separator

Influence of entrapped gas morphology at liquid–solid interface on underwater drag reduction effect

Numerical investigation of gas permeation and condensation behavior of flexible risers

Numerical Study of Supersonic Jet Characteristics of Underwater Solid Rocket Engine

LES investigation on cavitating flow structures and loads of water-exiting submerged vehicles using a uniform filter of octree-based grids

Numerical research on the high-speed water entry trajectories of AUVs with asymmetric nose shapes

Experimental Investigation on Underwater Drag Reduction Using Partial Cavitation

8QGHUZDWHUGUDJ UHGXFWLRQE\JDV

Numerical investigation of the cavitation bubble near the solid wall with a gas-entrapping hole based on a fully compressible three-phase model

Experimental investigation on flow structure and pressure characteristics of submerged high-speed gaseous jets under co-flow conditions