Abstract:The purpose of this article is to analyze the front door coupling effect that may occur in the projectile receiver due to the discharge pulse radiation in electromagnetic railguns, and to simulate the discharge pulse interference. This phenomenon will have an impact on the launch of the projectile, causing its fuse to be disturbed, ultimately affecting the weapon performance of the electromagnetic railgun. Discharge refers to when the armature carrying the projectile is fired out of the chamber, and the armature connected between the two rails detaches, causing a circuit break in the electrical circuit during the operation of the electromagnetic railgun. The current flowing through the armature is disturbed, causing an instantaneous high voltage to penetrate the air gap between the two rails, generating nanosecond pulse width discharge voltage pulse radiation, with a spectrum of up to tens of megahertz. In this paper, we establish a receiving antenna model on the projectile, which is essentially a horn antenna, receiving electromagnetic pulses from the discharge process, and coupling the pulse interference through its front door. During the analysis and calculation, we established an antenna receiver model located in the C-band with a frequency of 6 GHz for simulation, analyzed and calculated the actual interference loaded on the projectile after front door coupling, and verified the correctness of the simulation settings and results by comparing with the literature. Finally, we found that because the main energy spectrum of the pulse is at MHz level, when the front door of the C-band horn antenna is coupled, the standing wave ratio of the antenna is very large and the gain is very small, so the pulse interference is filtered, which can make the interference finally loaded on the projectile insufficient to affect the normal operation of the projectile. At the same time, it is recommended to add an RF filter to the receiving channel to further enhance anti-interference ability, so as to ultimately enable the electromagnetic railgun to function properly.

Analysis of parameter sensitivity of electromagnetic railgun system

Researches on the System Launch Efficiency and the Armature Muzzle Kinetic Energy of a Constructed Electromagnetic Railgun

Performance Analysis and Parameter Optimization of CPPS-Based Electromagnetic Railgun System

Study on the System Efficiency of the Synchronously-Triggered Capacitive Pulsed-Power Supply in the Electromagnetic Railgun System

Dynamic response of electromagnetic railgun under time-dependent electromagnetic moving loads

A Closed-Loop Velocity Control System for Electromagnetic Railguns

Analysis of the Research Progress of Electromagnetic Railgun Based on CiteSpace

Electromechanical Performance of Rails With Different Cross-Sectional Shapes in Railgun

Armature Velocity Control Strategy and System Efficiency Optimization of Railguns

Energy Conversion Efficiency of Electromagnetic Launcher with Capacitor-Based Pulsed Power System

Analysis of sliding electric contact characteristics in augmented railgun based on the combination of contact resistance and sliding friction coefficient

Investigation of the Distribution Problem in the Operating State of an Electromagnetic Railgun: Radio Fuse Disturbance, Field Characteristics, and Susceptible

Triggering Strategy of Railgun Power Supply for the Accurate Control of the Armature Muzzle Velocity

An Automatic Calculation Method for the Triggering Strategy of the Capacitive Pulsed-Power Supply

Effect of driving current profile on acceleration efficiency of electromagnetic railgun

A Review of the Computational Investigation of Three-Dimensional Transient Magneto-Thermal Coupling Characteristics of Electromagnetic Railgun Armature and Rail in High-Speed Sliding Electrical Contact

Finite Element-Boundary Element Method Based Simulations of Electromagnetic Railgun in Augmented Configurations

Modeling of the Rail Type Electromagnetic Launch System With Superconducting Pulsed Power Supply Considering Resistance

Research on Interior Ballistic Mechanics of Electromagnetic Railgun

A TIME-STEPPING FEM FOR TRANSIENT ELECTROMAGNETIC FILED ANALYSIS AND LEVITATION AND PROPELLANT FORCE STUDY OF AN EMS MAGLEV TRAIN

A Novel Magnetic Coupled Railgun System Based on Inductive Pulsed Power Supply—Preliminary Theoretical Analysis and Experiment Study