Abstract:Maintaining stability remains a crucial issue for the safety of underwater vehicles, especially during high-speed navigation where flow cavitation may occur. Cavitators are small protrusions on the hydrofoil surface, which can be used to control the patterns of flow cavitation. In this study, we investigate the effect of cavitators on supercavitating flow and hydrodynamic forces for high-speed hydrofoil. The volume of fluid method and the large eddy simulation turbulence model with the Kunz cavitation model are used in the simulations in order to accurately capture the interface between two phases (water and vapor) and the region of flow supercavitation. To validate the numerical method, the time-averaged simulated results of the supercavitating flow over a wedge-shaped hydrofoil are compared and validated against the experimental data by Kermeen ("Experimental investigations of three-dimensional effects on cavitating hydrofoils," Technical Report No. 47-14, Engineering Division of the California Institute of Technology, Pasadena, CA, 1960). Then, the numerical method is used to simulate the supercavitating flow of two-dimensional and three-dimensional cases with and without the cavitator placed on the lower side of the hydrofoil. The simulations were conducted for the cavitator located at the 1/32, 1/16, 1/8, and 1/4 chord of the hydrofoil at various angles of attack 1°–12° and cavitation numbers at 0.1, 0.2, and 0.4. A detailed analysis is made to examine the relations between cavitation pattern, hydrodynamic forces, and cavitator placement location. Compared to the cases without the cavitator, the supercavitating flow over the hydrofoils controlled by the cavitator demonstrates a significant difference in lift, whereas the drag does not change much. The changes in lift are closely related to the cavitator location. These findings can serve as a good guidance on how to improve the hydrodynamic performance and stability condition of a high-speed hydrofoil/wing using the cavitator.

A study on trajectory characteristics of supercavitating vehicle based on CFD

Unsteady Flow Simulation of a Variable-Sweep Morphing Aircraft Coupled with Flight Control System

Research on Hydrodynamics of Trans-Media Vehicles Considering Underwater Time-Varying Attitudes

Dynamics of the supercavitating hydrofoil with cavitator in steady flow field

Numerical analysis of cavitation and impact load characteristics of supercavitating vehicle entering water at high speed

Numerical Study on the Control Mechanism of Cloud Cavitation by Obstacles

Numerical research on the high-speed water entry trajectories of AUVs with asymmetric nose shapes

A Lagrangian Analysis of Partial Cavitation Growth and Cavitation Control Mechanism

Design of H∞ state feedback controller for lateral motion of supercavitating vehicle

Motion Characteristics of High-Speed Supercavitating Projectiles Including Structural Deformation

Numerical–experimental study on the stability mechanism of tail slapping motion of supercavitation projectile

Numerical Investigation on the Cavity Behavior and Hydrodynamic Performance of a Planing Air Cavity Ship

Water entry experiment of a cylindrical vehicle with disc cavitator

On the Validation of the Cavitation Model Considering the Thermodynamic Effect of Cavitating Flow

Numerical Investigations of Cavitation Nose Structure of a High-Speed Projectile Impact on Water-Entry Characteristics

Free surface and near-wall effects on the cloud cavitating flow over an axisymmetric projectile

On the cavity flow of a cylinder exiting water obliquely

Numerical Study on the Vertical Water Exit of A Cylinder with Cavity

Finding optimal hull shapes for fast vertical penetration into water

Simulation About 3D Flow Field of Missile Underwater Motion and Water-exit Process

Examining the Influence of the Water Entry Velocity of Projectiles on Supercavity Flow and Ballistic Characteristics under Wave Conditions