Abstract:In the process of underground construction, it is common to spray concrete on the working surface, which will form a concrete-rock composite structure, to achieve the expected reinforcement effect. Compared with pure concrete or rock structures, composite structures have different mechanical properties, energy evolution and damage characteristics. Understanding the dynamic mechanics and damage characteristics of composite structures under impact loads is important to the safety of underground engineering construction. First, dynamic compression tests on different grades of mortar-sandstone composite specimens were carried out by using a Hopkinson pressure bar system to discuss the effect of impact velocities on the mechanical properties and failure modes of composite specimens. The results show that the dynamic peak stress, strain energy density and fragmentation block of the mortar-sandstone composite have an obvious strain rate effect. With an increase in impact velocity, the internal cracks of the sample do not have sufficient time to expand, and the energy absorbed by the sample leads to the continuous initiation of new cracks in the sample, resulting in an increasing damage degree of composite specimens. The increase in mortar strength can significantly increase the peak stress, improve the load-bearing capacity of the sample, and reduce the degree of sample damage. At the same impact velocity, the fragmentation degree of the mortar sample is more severe than that of sandstone, and the mortar sample is broken into powder debris, while the sandstone is broken into fragments. In addition, according to the failure properties of the composite sample, the mortar and sandstone samples are described by different damage models, and the dynamic damage constitutive model of the mortar-sandstone composite is established based on the overlay principle. The dynamic test results were fitted. The research shows that the fitting curves of the model are well fitted with the test curves and that the model accurately reflects the changes in the mechanical parameters of the composite specimens.

Stress-Strain Behavior and Statistical Continuous Damage Model of Cement Mortar under High Strain Rates

Effect of Strain Rate and Water-to-cement Ratio on Compressive Mechanical Behavior of Cement Mortar

Experimental Study on Dynamic Tensile Strength of Cement Mortar Using Split Hopkinson Pressure Bar Technique

Compressive Behavior of Engineered Cementitious Composites under High Strain-Rate Loading

Influence of Water-to-cement Ratio on Dynamic Compressive Behavior for Cement Mortar under High Strain Rate

Experimental and modeling study of dynamic mechanical properties of cement paste, mortar and concrete

Quantification of Dynamic Tensile Behavior of Cement-Based Materials

Influence of Free Water Content on the Compressive Mechanical Behaviour of Cement Mortar under High Strain Rate

Damage Based Constitutive Model for Predicting the Performance Degradation of Concrete

Experimental study of dynamic axial tensile constitutive relationship for mortar

Experimental Research on Static and Dynamic Characteristics of Cement Soil under Strain Control

Dynamic behavior of cement mortar under confinement

Quasi-static and Dynamic Experimental Studies on the Tensile Strength and Failure Pattern of Concrete and Mortar Discs

Dynamic mechanical properties of cement and asphalt mortar based on SHPB test

Effect of Testing Method and Strain Rate on Stress-Strain Behavior of Concrete

Strain-rate sensitivity of concrete: Influence of moisture content

Dynamic and Damage Characteristics of Mortar Composite under Impact Load

The Influence of the Strain Rate and Prestatic Stress on the Dynamic Mechanical Properties of Sandstone—A Case Study from China

STRAIN RATE EFFECTS ON THE BEHAVIOR OF CONCRETE AND THE SEISMIC RESPONSE OF CONCRETE STRUCTURES

Dynamic Behavior of Cement Mortar under Active Confinement

Parametric Analysis on Compressive Strain Rate Effect of Concrete Using Mesoscale Modeling Approach