The Influence of the Disturbing Effect of Roadways Through Faults on the Faults' Stability and Slip Characteristics
Shuaifeng Lu,Andrew Chan,Xiaolin Wang,Shanyong Wang,Zhijun Wan,Jingyi Cheng
DOI: https://doi.org/10.1002/dug2.12119
2024-01-01
Abstract:In order to mitigate the risk of geological disasters induced by fault activation when roadways intersect reverse faults in coal mining, this paper uses a combination of mechanical models with PFC2D software. A mechanical model is introduced to represent various fault angles, followed by a series of PFC2D loading and unloading tests to validate the model and investigate fault instability and crack propagation under different excavation rates and angles. The results show that (1) the theoretical fault model, impacted by roadway advancing, shows a linear reduction in horizontal stress at a rate of -2.01 MPa/m, while vertical stress increases linearly at 4.02 MPa/m. (2) At field excavation speeds of 2.4, 4.8, 7.2, and 9.6 m/day, the vertical loading rates for the model are 2.23, 4.47, 6.70, and 8.93 Pa/s, respectively. (3) Roadway advancement primarily causes tensile-compressive failures in front of the roadway, with a decrease in tensile cracks as the stress rate increases. (4) An increase in the fault angle leads to denser cracking on the fault plane, with negligible cracking near the fault itself. The dominant crack orientation is approximately 90 degrees, aligned with the vertical stress. The main aim of this research is to investigate the stability of tunnels through fault zones with various parameters, such as exaction speed and fault angles. For this purpose, the mechanical model was used for simplifying the fault mechanics environments and PFC2D was used to analyze the effect of excavation parameters on fault stability. Also, a stress rate relationship was established on laboratory and field scales based on the similarity principle. Finally, suitable excavation parameters have been chosen for this paper, incorporating the results of numerical simulations. image The mechanical model of fault activation induced by roadway excavation was established with the plane strain theory. The loading rate relationship between the numerical simulation model and field scale was developed. The influence of fault angles and roadway excavation speed on the fault instability was investigated.