Abstract:A novel design concept of molten salt pebble-bed reactor with an ultra-simplified integral primary circuit called "Nuclear Hot Spring" has been proposed, featured by horizontal coolant flow in a deep pool pebble-bed reactor, providing "natural safety" features with natural circulation under full power operation and less expensive primary circuit arrangement. In this work, the steady-state physical properties of the equilibrium state of the molten salt pebble-bed reactor are calculated by using the VSOP code, and the steady-state thermo-hydraulic analysis is carried out based on the approximation of absolutely horizontal flow of the coolant through the core. A new concept of 2-dimensional, both axial and radial, multi-pass on-line fuelling scheme is presented. The result reveals that the radial multi-pass scheme provides more flattened power distribution and safer temperature distribution than the one-pass scheme. A parametric analysis is made corresponding to different pebble diameters, the key parameter of the core resistance and the temperature at the pebble center. It is verified that within a wide range of pebble diameters, the maximum pebble center temperatures are far below the safety limit of the fuel, and the core resistance is considerably less than the buoyant force, indicating that the natural circulation under full power operation is achievable and the ultra-simplified integral primary circuit without any pump is possible. For the kinetic properties, it is verified that the negative temperature coefficient is achieved in sufficient under-moderated condition through the preliminary analysis on the temperature coefficients of fuel, coolant and moderator. The requirement of reactivity compensation at the shutdown stages of the operation period is calculated for the further studies on the reactivity control. The molten salt pebble-bed reactor with horizontal coolant flow can provide enhanced safety and economical features.

Software Development for Pebble-bed MSR Calculation

Extended development of a Monte Carlo code OpenMC for fuel cycle simulation of molten salt reactor

Development of A Safety Analysis Code for Molten Salt Reactors

Numerical Analysis for a Molten Salt Reactor in the Presence of Fissile Lump

High-fidelity Neutronics Simulation of Channel-Type Molten Salt Reactors

Neutronics/Thermal-hydraulics Coupling Analysis for the Liquid-Fuel MOSART Concept

Numerical Analysis for a Molten Salt Reactor in the Presence of Localized Perturbations

Fuel Cycle Analysis of Molten Salt Reactors Based on Coupled Neutronics and Thermal-Hydraulics Calculations

STEADY THERMAL-HYDRAULIC ANALYSIS FOR THE CORE OF A NEW CONCEPT MOLTEN SALT REACTOR

Three Dimensional Neutronic/thermal-Hydraulic Coupled Simulation of MSR in Transient State Condition

Improvements and Validation of the Transient Analysis Code MOREL for Molten Salt Reactors

Coupled Neutronics/thermal-Hydraulics for Analysis of Molten Salt Reactor

Studies on the molten salt reactor. Code development and neutronics analysis of MSRE-type design

The Optimization Design Of Lower Plenum And Distribution Plates In Msr

The preliminary analysis on the steady-state and kinetic features of the molten salt pebble-bed reactor

Numerical Analysis on the Dynamic Behaviors of a Graphite-Moderated Molten Salt Reactor Based on MOREL2.0 Code

Thermal-hydraulic Design and Analysis of a Small Modular Molten Salt Reactor (MSR) with Solid Fuel

Three dimensional steady‐state neutronics/thermal‐hydraulics coupled simulation for a molten salt reactor moderated by zirconium hydride rods

COUPLE, A Time-Dependent Coupled Neutronics and Thermal-Hydraulics Code, and its Application to MSFR

Multi-physics numerical analysis of the fuel-addition transients in the liquid-fuel molten salt reactor

Three-dimensional Code Development for Steady State Analysis of Liquid-fuel Molten Salt Reactor