Abstract:Abstract: Novel nanostructured iron oxide-reduced graphene oxide composites were synthesized by a facile one-step hydrothermal method in an ethylene glycol (EG)–water system. Different phases of iron oxides were detected by adjusting fabrication parameters including the EG/H2O ratio, base content and iron ions concentration. Electrochemical propertyof fabricated nanocomposites as anode material was examined in a coin–type cell. The high–rate capacity and cycling stability were found, which is attributed to the improved lithium storage capability due to the application of graphene sheet acting as conductive materials for iron oxide nanoparticles. This study provides a favorable approach for exploring the nanocomposites of metal oxide-graphene anode for lithium ion battery applications. Introduction: Currently,α–Fe2O3 has been considered as a promising candidate for lithium ion batteries due to its much higher theoretical capacity of 1350 mAhg‾1 than that of commercial graphite anode materials and its environmental friendly fabrication methods from low–cost resources [1]. In particular, the use of nanomaterials is an effective path to improve rate capabilities of solid state electrodes in batteries attributed to their relatively small diffusion lengths. Furthermore,graphene, with an excellent electronic conductivity, a high theoretical surface area of 2630 m2/g and superior mechanical properties, is a significantly promising component for high performance electrode materials [2]. In this study, an anode material of iron oxide nanoparticles (mainly α–Fe2O3)–reduced graphene oxide for lithium ion battery has been synthesized and reported. Experimental: FeCl3·6H2O (1.08 g) and NaOH (0.8 g) was dissolved in EG (30 ml) by ultrasonication for 1 hour.Then 10 ml deionized water and 15 mg graphene oxide was added to the mixture under stirring to get a homogeneous solution. The solution was transferred into a 50 ml teflon–lined stainless steel autoclave, sealed and heated at 200oC for 10 hours. The product was collected by centrifuging and washed by ethanol and deionized water alternatively for several times, which was followed by drying at 80oC. Morphologies and phases of synthesized nanocomposites were characterized by scanning electron microscopy (SEM), Raman scattering spectroscopy, X-ray diffraction (XRD), high resolution transmission electron microscopy(TEM). Results: Typical XRD pattern of the products was illustrated in Fig.1 that demonstrated the co–existence of α–Fe2O3 and Fe3O4. Diffraction peaks can be indexed to either the rhombohedral phase of α-Fe2O3 (JCPDS NO.84-0307) or the cubic phase of Fe3O4 (JCPDS NO.65-3107). The characteristic peak of graphene oxide located at 10.4° was not found, confirming the formation of graphene. Fig. 1 also showed the SEM image of fabricated iron oxide nanoparticles that were uniform with the diameter about 50 nm, indicating XRD pattern in good agreement with SEM results. Raman spectra also confirmed that the typical features of reduced graphene oxide with the presence of D band (1348 cm−1) and G band (1598 cm−1). References: [1] P. C. Wang, H. P. Ding, Tursun Bark, and C. H. Chen, Electrochimica Acta,52 (2007) 6650–6655 [2] S. Stankovich, D. A. Dikin, G. H. B. Dommett, K.M. Kohlhaas, E. J. Zimney, E. A. Stach, R. D. Piner, S.T. Nguyen, and R.S. Ruoff, Nature, 442 (2006) 282–286

Graphene/metal Oxide Nanocomposites for Li-ion Batteries

Graphene/metal Oxide Composite Electrode Materials for Energy Storage

Synergistic Ternary Composite (carbon/fe3 O4 @graphene) with Hollow Microspherical and Robust Structure for Li-Ion Storage.

Nanocomposite of Iron Oxide-Reduced Graphene Oxide Applied As High-Performance Anode Materials for Lithium Ion Batteries

Graphene-Based Materials for Lithium-Ions Batteries

Boosting the lithium and sodium storage performance of graphene-based composite via pore engineering and surface protection

An Effective Way to Optimize the Functionality of Graphene-Based Nanocomposite: Use of the Colloidal Mixture of Graphene and Inorganic Nanosheets

In Situ Self-Assembled FeWO4/Graphene Mesoporous Composites for Li-Ion and Na-Ion Batteries

A simplified electrophoretic deposition route for sandwiched structure-based Mn3O4/G composite electrodes as high-capacity anodes for lithium-ion batteries

Facile Ultrasonic Synthesis of CoO Quantum Dot/Graphene Nanosheet Composites with High Lithium Storage Capacity

Composites of Reduced Graphene Oxide and Fe 2 O 3 Nanoparticles Anchored on MoS 2 Nanosheets for Lithium Storage

Metal Oxide Wrapped by Reduced Graphene Oxide Nanocomposites as Anode Materials for Lithium-Ion Batteries

Comprehensive Enhancement Of Nanostructured Lithium-Ion Battery Cathode Materials Via Conformal Graphene Dispersion

Stabilized Li metal anode with robust C-Li3N interphase for high energy density batteries

A ternary oxygen-vacancy abundant ZnMn2O4/MnCO3/nitrogen-doped reduced graphene oxide hybrid towards superior-performance lithium storage

Design of pseudocapacitance and amorphization Co-enhanced Mn3O4/graphene sheets nanocomposites for high-performance lithium storage

Optimization of NiFe2O4/rGO Composite Electrode for Lithium-Ion Batteries

Graphene-modified Nanostructured Vanadium Pentoxide Hybrids with Extraordinary Electrochemical Performance for Li-ion Batteries

Fabrication of Graphene Nanoplatelets-Supported Siox-Disordered Carbon Composite and Its Application in Lithium-Ion Batteries

Nanocarbon/Metal Oxide Hybrids for Lithium Ion Batteries

General Synthesis of Graphene/Metal Oxide Heterostructures for Enhanced Lithium Storage Performance