Abstract:During the commissioning of Nuclear power plant unit, it is necessary to perform the transient condition test that the single pump operation of Main Feedwater (APA) pump triggers the rapid load rejection of steam turbine. Due to the sudden loss of a main water supply pump during the test, the level of the steam generator will change dramatically. If there is a signal of "SG level low plus steam / water flow mismatch" or a signal of "SG level low low", the reactor trip protection will be triggered. PI controller is used as the core controller of the main feed water pump control process. The optimal parameters of PI controller directly affect the level control performance of steam generator. At present, the units that have completed the test only verify that the control system meets the requirements of transient conditions, but it does not solve the phenomenon that the oscillation frequency of the feed water regulating system is too high under stable conditions. In this paper, the safety range of the control parameters under transient condition is determined by simulation model test, and then the steady-state performance of the parameters is improved by field test, so the optimization of the control parameters is completed, and the regulation performance of the feed water control system under single pump operation and steady-state condition of the main feed water pump is improved, and practical results are achieved. The results show that the optimization of the controller parameters in this paper can meet the requirements of transient conditions, and can effectively increase the stability of the control system. This research method has been successfully applied in generation II unit, and it is also useful for the generation-III unit.

PD Power-Level Control Design for PWRs: A Physically-Based Approach

Adaptive Proportional-Differential Power-Level Control for Pressurized Water Reactors

Can General Pd Output-Feedback Laws Be Asymptotic Power Stabilizers Of Pressurized Water Reactors?

Nonlinear Dynamic Output-Feedback Power-Level Control for PWRs: A Shifted-Ectropy Based Design Approach

Self-Stability Analysis And Nonlinear Power-Level Control For Pressurized Water Reactors

Shifted-ectropy based nonlinear dynamic output-feedback power-level control for pressurized water reactors

Study on Optimization of PID for Feed-water Control System of RB Test in PWR Nuclear Power Station

PD Power-Level Control Design for MHTGRs

Model Simplification of Nuclear Power Plant for Power System Dynamic Simulation

ICONE23-1973 A SUFFICIENT CONDITION FOR PD OUTPUT FEEDBACK LAWS TO BE ASYMPTOTIC HTGR POWER-LEVEL CONTROLLERS

Passivity-Based Power-Level Control of Nuclear Reactors

PWR Power-Level Control Only with Coolant Temperature Measurement

An Expert PID Control Method for Level Control of CFB Boiler

Passivity-Based Control of Nuclear Reactors

Physically-Based Power-Level Control for Modular High Temperature Gas-Cooled Reactors

Power-Level Control of Nuclear Reactors Based on Feedback Dissipation and Backstepping

Sufficient Conditions for Globally Asymptotic Self-Stability of Pressurized Water Reactors

Mlp Compensated Pd Power-Level Control for Modulator High Temperature Gas-Cooled Reactors

Nonlinear adaptive dynamic output-feedback power-level control of nuclear heating reactors

ICONE19-44002 POWER-LEVEL CONTROL OF HIGH TEMPERATURE REACTORS BASED ON FEEDBACK DISSIPATION AND BACKSTEPPING

Adaptive Neuro-Fuzzy Self Tuned-PID Controller for Stabilization of Core Power in a Pressurized Water Reactor