An Investigation on the H2O, Unburned H2 and NO Emission Characteristics from a Direct Injection Hydrogen Engine
Yajuan Chen,Diming Lou,Yunhua Zhang,Liang Fang,Dongxia Yang,Dezhi Ren,Guofu Song
DOI: https://doi.org/10.1016/j.ijhydene.2024.07.368
IF: 7.2
2024-01-01
International Journal of Hydrogen Energy
Abstract:Hydrogen engines show great potential as a power source with good combustion performance, zero carbon emissions, and diverse sources. However, the exhaust emission characteristics with high water vapor (H2O) content have not yet been clarified. This study presents the exhaust emissions of a heavy-duty direct-injection hydrogen engine under various operational parameters, with a focus on the H2O content. The results reveal important exhaust emissions characteristics of the hydrogen engine, including lower exhaust temperature (200 degrees C-400 degrees C), higher unburned H-2 emissions (up to 17100 ppm), less nitrogen oxide (NO) generation (<1000 ppm), and higher H2O content (6%-40%). Additionally, unburned H-2 rises, and NO and H2O decrease as the excess air ratio (lambda) increases. When lambda is greater than 3, NO levels fall sharply to below 100 ppm. Optimal emissions performance is achieved with a 5 degrees CA BTDC ignition timing where low levels of H-2, H2O, and NO are maintained. Increasing hydrogen injection pressure decreases H-2 but raises exhaust temperature, H2O, and NO emissions. Excessively delaying hydrogen injection timing adversely affects the concentration gradient in the cylinder, increasing unburned H-2 emissions. The best emissions performance is observed at a hydrogen injection timing of 110 degrees CA BTDC.