Abstract:The wind energy exploitation technique has been developed very quickly in recent years. The vertical axis wind turbine is a hot research domain due to several advantages: low noise, flexible for installation, ease of maintenance, great safety and credibility, etc. The aerodynamic performances of different forms of airfoils including an active deformation airfoil and a fluid-solid coupling passive airfoil with two-dimensional (2D) and three-dimensional (3D) cases have been investigated numerically in this paper. Firstly, the aerodynamic performances of the airfoils with the maximum deformation amplitudes of their cambers which are 3%, 5% and 7% of the chord length have been discussed, respectively, with the angles of attack in the range of 0° and 20°. Secondly, for the angle of attack set at 18°, the two-way fluid-solid coupling simulations with the Young’s Modulus of 1 Mpa and 2 Mpa have also been investigated. Results show that: (1) for the pseudo 3D and real 3D single active deformation airfoil cases, the lift coefficients increase as the maximum deformation amplitudes augment from 3% to 7% of the chord length at the same angle of attack. With the same maximum deformation amplitude, when the angles of attack increase from 0° to 20°, the lift coefficients which increase firstly and then decrease are bigger than that of the original NACA0012 airfoil. When the maximum deformation amplitude of the pseudo 3D airfoil reaches 5% of the chord length, a relatively good aerodynamic performance with better inhibition effect of vortex generation can be obtained. The 3D vortex distribution demonstrates that the deformable airfoil has a better vortex generation controlling effect at the middle cross-section along the spanwise direction than the non-deformable airfoil. (2) From the aspect of fluid-solid coupling, the lift increases and the drag decreases so that the lift to drag ratio has a big improvement when the Young’s Modulus is equal to 1 Mpa and 2 Mpa. The deformable airfoil can inhibit the generation and the shedding of the surface vortex when the fluid-solid coupling effect is considered.

EXPERIMENT AND ANALYSIS OF AERODYNAMIC PERFORMANCE FOR CAS THIN AIRFOILS USED OF WIND TURBINE BLADES

Airfoil Parameterization Evaluation Based on a Modified PARASEC Method for a H-Darrious Rotor

Influence of Relative Thickness on Static and Dynamic Stall Characteristics and Prediction of Airfoils

Numerical Analysis of Leading-Edge Roughness Effects on the Aerodynamic Performance of a Thick Wind Turbine Airfoil

A Combined Method of CFD Simulation and Modified Beddoes-Leishman Model to Predict the Dynamic Stall Characterizations of S809 Airfoil

Simulation Analysis and Experimental Study on Airfoil Optimization of Low-Velocity Turbine

AERODYNAMIC PERFORMANCE INFLUENCE WITH ROUGHNESS ON WIND TURBINE AIRFOIL SURFACE

SIMULATION OF 2D FLOW AROUND OF AIRFOILS AT LOW-SPEED WIND TUNNEL WITH OPEN JET TEST-SECTION

Study on Airfoils and Aerodynamics of High-Speed Aircraft Propeller

Study change of the performance of airfoil of small wind turbine under low wind speed by CFD simulation

Simulation of flow over double-element airfoil and wind tunnel test for use in vertical axis wind turbine

Optimized design of wind turbine airfoil aerodynamic performance and structural strength based on surrogate model

A Method to Design an Efficient Airfoil for Small Wind Turbines in Low Wind Speed Conditions Using XFLR5 and CFD Simulations

Design and experimental validation of a specialized pressure-measuring rake for blended wing body aircraft’s unconventional inner flow channel

Effects of Simulated Surface Roughness on Flow Characteristics in Symmetrical Airfoil

Performance optimization and investigation of flow phenomena on tidal turbine blade airfoil considering cavitation and roughness

Wind Tunnel Testing and Modeling Implications of an Advanced Turbine Cascade

Investigation on drag reduction on rotating blade surfaces with microtextures

Numerical Study on Aerodynamic Performance of Different Forms of Adaptive Blades for Vertical Axis Wind Turbines

Numerical simulation of an airfoil for stall regulated HAWT rotors at large angles of attack

Research on the pressure distribution under different airfoil types of aircraft