Abstract:In this paper, a model of flood area display and damageevaluation is discussed, which adopts seed spread algorithm to calculate and visualize flood area based on a DEM data set and under the condition of a given water level of flood. The raster image containing flood area is overlaid with raster data converted from thematic vector maps such as land-use map and related to other socio-economic data, and then quantitative evaluation of flood damage is achieved. There are two different cases, the so-called “non-source flood” and “source flood”, for determining flood area based on DEM and under the given water level condition. Non-source flood corresponds to the case with well-distributed and large-area rainfall where all the low-lying land may have a flood disaster, and in this case all the points with elevations below the given water level should be included in the flood area. The “source flood” is the case of flood (e.g. from bank burst) flushing through the surrounding lands that needs to consider “ci rculating” condition. Because flood may be obstructed by ring structures or high lands, thus it can only cover the place where it flows and reaches. One of the computer processing methods suitable for source flood is the seed-spread algorithm. The principle of this method is to select a representative pixel as a seed and to examine its contiguous pixels outward along 4 or 8 directions. The pixels, contiguous to it and meeting the given conditions, become seeds, and then contiguous pixels to the new seeds will be examined in the same way. This process repeats until an aggregation of the pixels which meet the given conditions on a certain plane are obtained. Adopting seed spread algorithm for source-flood area calculation is just to achieve an aggregation of pixels, which satisfies the connectivity requirement and the given conditions of water level. The initial position of seed pixel should usually be selected on the characteristic points, e.g. adjacent to a reservoir dam or stream boundary. The precision of flood area calculation is mainly determined by spatial resolution of the DEM, the area on the ground is represented by each pixel; whereas the accuracy of flood area calculation, to a great extent, is dependent on the preci sion of the DEM's pixel value or elevation.Once the area below the flood water level has been calculated, the flood damage evaluation can be calculated by overlaying the flood range with thematic maps and by relating to other socio-economic data. All thematic maps were converted to raster data because algorithm of the overlay analysis implemented in raster format is relatively simple and computing is fast. In order to improve accuracy of the flood damage evaluation it is necessary to accurately register and georefer all raster layers before overlay analysis. The calculation results of flood damage evaluation are generally represented by tabulation, which is a kind of classified statistics of flood damage data, e.g. a table representing total area of every land-use type in different administrative divisions. The results of flood area calculation and damage evaluation can also be visually and dynamically provided in the forms of graph, image, 3D or virtual reality. The model has been successfully applied in the “Zhejiang Provincial Water Conservancy Management System” developed for a national project.

Basic paradigm of risk analysis in flood disaster and its application

Hydrological Extreme Analysis and Its Uncertainty

Review of Risk Analysis on Flood

A GIS-based Method for Flooded Area Calculation and Damage Evaluation

Dam-break Flood Loss Assessment in Hurricane-Prone Regions

A GIS Based Model for Calculating of Flood Area

Risk analysis in floods

Extremal Analysis of Flooding Risk and Management

Flood risk assessment in metro systems of mega-cities using a GIS-based modeling approach

Comprehensive evaluation of urban flood-bearing risks based on combined compound fuzzy matter-element and entropy weight model

Risk assessment of individuals exposed to urban floods

Study on Fuzzy Risk Analysis of Flood Disasters Based on Interior-Outer-Set Model

Micro-scale Flood Hazard Assessment Based on Catastrophe Theory and an Integrated 2-D Hydraulic Model: A Case Study of Gongshuangcha Detention Basin in Dongting Lake Area, China

Risk Assessment and Management Method of Urban Flood Disaster

The application and prospect of risk analysis in flood in the past 25 years

Comprehensive Risk Assessment of Farmer Households in Flood and Earthquake Prone Areas Based on Multidimensional Information Diffusion Model

STUDY AND APPLICATION OF FLOOD CONTROL RISK TREND ANALYSIS MODEL

An assessment of multidimensional flood vulnerability at the provincial scale in China based on the DEA method

Dynamic risk assessment of urban flood disasters based on functional area division-A case study in Shenzhen, China

Risk Assessment of Urban Infrastructure Vulnerability to Meteorological Disasters: A case study of Dongguan, China

Urban flooding risk assessment based on FAHP–EWM combination weighting: a case study of Beijing