Abstract:Roughness effect parameterization is critical to accurately simulate brightness temperature (Tb) signals observed by a radiometer over bare soil surface. However, current roughness parameterization schemes usually suffer from severe error, which dominates the error budget in current Tb modeling over bare soil surface. In this study, uncertainty of soil roughness parameterization schemes is comprehensively assessed using data set collected during 2004 to 2006 at the Surface Monitoring Of the Soil Reservoir Experiment (SMOSREX) bare soil experimental site. To reduce uncertainty from sampling depth mismatch, the soil moisture profile with a 1cm thickness from a calibrated Hydus-1D (H1D) model is utilized to determine the optimal soil moisture inputs to soil emission model. Uncertainties of 15 literature-based roughness effect parameterization schemes developed for L-band Tb modeling are inter-compared. The “Q/H” model is further calibrated against multi-angle and dual-polarization Tb observations at the SMOSREX bare soil site under different roughness conditions. Our results show that: (1) soil moisture sampling depth varies with soil moisture content and roughness condition. When soil is drier and rougher, the soil moisture sampling depth gets deeper. (2) The 15 roughness schemes generally perform better at vertical polarization than at horizontal polarization and better when soil surface is relative smooth than when soil surface gets rougher. The 15 roughness correction schemes have their own advantages and disadvantages with diverse error and bias characteristics. None of them has a superior performance at all conditions in terms of roughness, polarizations and incident angles. (3) A non-zero Q configuration is preferred in parameter retrieval experiments and the observed linear relationship between ΔN and root-mean-square height (σ) or σ2/LC can only be reproduced when Q is non-zero in parameter retrieval. (4) The effective roughness parameters (Q, Np and h) generally increase when soil get rougher. The calibrated Q, Nh and Nv show exponential dependence on the effective parameter h. The calibrated h still shows dependence on surface soil moisture after accounting the impact from soil sampling depth and also shows strong power-law dependence on Tb at incident angle of 40°. The non-zero-Q fitting models have comparable performance in Tb modeling with zero-Q models but may be more physically realistic.

An Improvement of Roughness Height Parameterization of the Surface Energy Balance System (sebs) over the Tibetan Plateau

Estimation of Surface Energy Fluxes in the Permafrost Region of the Tibetan Plateau Based on in Situ Measurements and the Surface Energy Balance System Model

Estimation of surface energy fluxes under complex terrain of Mt. Qomolangma over the Tibetan Plateau

A Temperature-Domain SEBAL Model Based on a Wind Speed-Independent Theoretical Trapezoidal Space Between Fractional Vegetation Coverage and Land Surface Temperature

Parameterization Improvement on Simulation of Surface Temperature and Energy Budget over Desert using BATS Model

An Approach for Surface Fluxes Estimations over Heterogeneous Terrain by Means of Remotely Sensed Data and Dem

Surface Flux Parameterization in the Tibetan Plateau

The influence of bare ground thermal roughness length parameterization on the simulation of near‐surface air and skin temperatures over the Tibetan Plateau

Surface Roughness Parameters Estimation Over The Tibetan Plateau: Optimization, Calibration And Validation In The Dense Soil Moisture Networks

Method Development for Estimating Sensible Heat Flux over the Tibetan Plateau from Cma Data

Surface Roughness Length Dynamic over Several Different Surfaces and Its Effects on Modeling Fluxes

Remote Sensing Based Continuous Estimation of Regional Evapotranspiration by Improved Sebs Model

Turbulent Flux Transfer over Bare-Soil Surfaces: Characteristics and Parameterization

Estimation of Ground Heat Flux and Its Impact on the Surface Energy Budget for a Semi-Arid Grassland

Re-estimation of the vertical sensible heat flux by determining the environmental temperature on a single-point tower measurement

Two Improvements of an Operational Two-Layer Model for Terrestrial Surface Heat Flux Retrieval

Evaluation of the Surface Urban Energy and Water Balance Scheme (SUEWS) at a Dense Urban Site in Shanghai: Sensitivity to Anthropogenic Heat and Irrigation

Evaluation of surface urban energy and water balance scheme (SUEWS) using scaled 2D model experiments under various seasons and sky conditions

Reappraisal of the Roughness Effect Parameterization Schemes for L-Band Radiometry over Bare Soil

Analysis of the Surface Energy Budget at a Site of GAME/Tibet using a Single-Source Model

Development of a Physically Based Soil Albedo Parameterization for the Tibetan Plateau