Abstract:The opto-electric servomechanism (OES) plays an important role in obtaining clear and stable images from airborne infrared detectors. However, the inherent torque disturbance and the noisy speed signal cause a significant decline in the inertial stability accuracy and low-speed performances of OESs. Traditional linear control schemes cannot deal with the nonlinear torque disturbance well, and the speed obtained by the finite difference (FD) method cannot effectively balance the tradeoff between the noise filtering and phase delay. Therefore, this paper proposes a strap-down stability control scheme, in the combination of a proportional-integral(PI) controller and a state-augmented Kalman filter (SAKF), where the PI is used to regulate the linear part of the servomechanism, and with the SAKF performing torque disturbance observation and speed estimation simultaneously. The principle and the implementation of the controller are introduced, and the tuning guidelines for the controller parameters are presented as well. Finally, the experimental verifications based on OESs with three transmission types (i.e., the direct-driving, the harmonic-driving, and the rotate vector-driving(RV-driving) OESs) are carried out respectively. The experimental results show that the proposed control scheme can perform better speed observation and torque disturbance compensation for various types of OESs, thus effectively improving the low-speed performance and stability accuracy of the mechanism.

A Discrete-Time Composite Switching Control Scheme for Performance Improvement in Servo Systems

A Fast Integral Sliding Mode Controller with an Extended State Observer for Position Control of Permanent Magnet Synchronous Motor Servo Systems

Research on control methods of permanent magnet synchronous motor position servo system

An Improved Composite Position Controller Based on Discrete-Time Terminal Sliding Mode Control for PMSM Servo System

A Novel Two-Phase Mode Switching Control Strategy for PMSM Position Servo Systems with Fast-Response and High-Precision

Servo Performance Improvement Through Iterative Tuning Feedforward Controller with Disturbance Compensator

Design and Implementation of an Electro-optical Tracking Servo System Via Composite Nonlinear Control Approach

A Speed Control for a PMSM Using Finite-Time Feedback Control and Disturbance Compensation

Precision Motion Control of Constrained SISO Nonlinear System Via Direct Optimized Compensation

A Look-Up Table Based Fractional Order Composite Controller Synthesis Method for the PMSM Speed Servo System

Composite nonlinear feedback–based adaptive integral sliding mode control for a servo position control system subject to external disturbance

An Intelligent Nonlinear Control Method for the Multistage Electromechanical Servo System

Composite finite-time control for PMSM with prescribed performance using disturbance compensation technique

High-Precision Anti-Interference Control of Direct Drive Components

A SAKF-Based Composed Control Method for Improving Low-Speed Performance and Stability Accuracy of Opto-Electric Servomechanism

Precise Position Control Based on Resonant Controller and Second-Order Sliding Mode Observer for PMSM-Driven Feed Servo System

Error Iterative Control Strategy for Permanent Magnet Synchronous Motor Servo System

Finite-time Control for Permanent Magnet Synchronous Motor Speed Servo System Via a Disturbance Observer.

Speed-command-independent Parameters Self-Tuning and Mismatch Compensation for Servo Speed Control

Continuous Nonsingular Fast Terminal Sliding Mode Control for Speed Tracking of PMSM Based on Finite Time Disturbance Observer

Composite Speed Control of PMSM Drive System Based on Finite Time Sliding Mode Observer