Abstract:Thermal insulation materials are widely used in the fields of thermal protection and the energy conservation at high temperature. Thermal conductivity is one of the most important parameters of characterizing the thermal insulation performance of thermal protection materials. Steady state method such as the guarded hot plate method is normally considered as the most accurate method to measure the thermal conductivity of thermal insulation materials, but the temperature range is limited to below 1000 K. Unsteady state method can be employed at higher temperature but the accuracy is lacking of validation. Consequently, thermal verification experiments are usually conducted by heating the front surface of thermal insulation materials to a very high temperature. However, it is difficult to obtain the temperature-dependent thermal conductivity by using the thermal insulation performance measured with a large temperature difference across the material. In this study, a sandwich structure experimental system is built to carry out the thermal insulation performance tests with a large temperature difference at both steady state and transient state. Both uniform temperature layer method and polynomial fitting method are adopted to extract the temperature-dependent thermal conductivity from the large temperature difference test at steady state. A new transient state identification method is proposed based on the niche genetic algorithm to identify the relation between thermal conductivity and temperature from the transient thermal response. The temperature-dependent thermal conductivity of four thermal protection materials are finally obtained. The identification results prove that the proposed transient identification method is reliable and robust.

Evaluation of thermal conductivity of insulation materials at high-temperature for longtime

Insulation Performance of Heat-Resistant Material for High-Speed Aircraft Under Thermal Environments

Measurement and identification of temperature-dependent thermal conductivity for thermal insulation materials under large temperature difference

A Theoretical analysis and experimental study of effective thermal conductivities of high temperature insulations

Research on insulation properties of high-speed aircraft lightweight heat-resistant materials in high-temperature environment

Theoretical and Experimental Study on a Compound Insulation System for High Temperature Applications

Experimental and theoretical studies on high-temperature thermal properties of fibrous insulation

Thermal analysis and performance study of high temperature fibrous insulation for metallic thermal protection system

Research on the Thermal Insulation Performance of High Temperature Gradient Composite Insulation Material

Simultaneous Reconstruction of Thermal Degradation Properties for Anisotropic Scattering Fibrous Insulation after High Temperature Thermal Exposures

Evolution of microstructures and thermal properties with heat treatment for absorbing, emitting and scattering fibrous medium

High Temperature Thermal Physical Properties of High-Alumina Fibrous Insulation

Method for measuring high heat flux density of aircraft for a long duration

An Experimental Study of Effective Thermal Conductivity of High Temperature Insulations

Testing Method of Effective Thermal Conductivity of Fibrous Insulations

Influence of Participating Radiation on Measuring Thermal Conductivity of Translucent Thermal Insulation Materials with Hot Strip Method

Heat Transfer Characteristics of High Temperature Multilayer Thermal Insulations

Thermal Conductivity Measurement of Carbon Felt Used in High Temperature Gas-cooled Reactor and Inverse Problem Calculation

Design of Thermal Protection Structures for High Temperature Thermophysical Property Testing System

Thermal Conductivity and Moisture Absorption of Biomass Materials as Thermal Insulators

Analysis of Heat Transfer and Effective Thermal Conductivity of High Temperature Fibrous Insulation for Thermal Protection System