The oxygen reduction reaction in solid oxide fuel cells: from kinetic parameters measurements to electrode design
Julián Ascolani-Yael,Alejandra Montenegro-Hernández,Diana Garcés,Quinyuan Liu,Hongqian Wang,Kyle Yakal-Kremski,Scott Barnett,Liliana Mogni
DOI: https://doi.org/10.1088/2515-7655/abb4ec
2020-10-01
Abstract:Abstract The research and development of new Solid Oxide Fuel Cell cathode materials is an area of intense activity. The kinetic coefficients describing the O 2 -reduction mechanism are the O-ion diffusion ( D chem ) and the O-surface exchange coefficients ( k chem ). These parameters are strongly dependent on the nature of the material, both on its bulk and surface atomic and electronic structures. This review discusses the method for obtaining the kinetic coefficients through the combination of electrochemical impedance spectroscopy with focused ion-beam 3D tomography measurements on porous electrodes (3DT-EIS). The data, together with oxygen non-stoichiometry thermodynamic data, is analysed using the Adler-Lane-Steele model for macro-homogeneous porous electrodes. The results for different families of oxides are compared: single- and double-layered perovskites with O-vacancies defects, based on La-Sr cobalt ferrites (La 0.6 Sr 0.4 Co 1-x Fe x O 3- δ , x = 0.2 and 0.8) and La/Pr-Ba cobaltites (La 0.5-x Pr x Ba 0.5 CoO 3- δ , x = 0.0, 0.2 and 0.5), as well as Ruddlesden-Popper nickelates (Nd 2 NiO 4 + δ ) with O-interstitial defects. The analysis of the evolution of molar surface exchange rates with oxygen partial pressure provides information about the mechanisms limiting the O 2 -surface reaction, which generally is dissociative adsorption or dissociation-limited . At 700 °C in air, the La-Ba cobaltite structures, La 0.5-x Pr x Ba 0.5 CoO 3- δ , feature the most active surfaces ( k chem ≃0.5–1 10 −2 cm.s −1 ), followed by the nickelate Nd 2 NiO 4 + δ and the La-Sr cobalt ferrites, with k chem ≃1–5 10 −5 cm.s −1 . The diffusion coefficients D chem are higher for cubic perovskites than for the layered ones. For La 0.6 Sr 0.4 Co 0.8 Fe 0.2 O 3- δ and La 0.6 Sr 0.4 Co 0.2 Fe 0.8 O 3- δ , D chem is 2.6 10 −6 cm 2 .s −1 and 5.4 10 −7 cm 2 .s −1 , respectively. These values are comparable to D chem = 1.2 10 −6 cm 2 .s −1 , observed for La 0.5 Ba 0.5 CoO 3- δ . The layered structure drastically reduces the O-ion bulk diffusion, e.g. D chem = 1.3 10 −8 cm 2 .s −1 for the Pr 0.5 Ba 0.5 CoO 3- δ double perovskite and D chem ≃2 10 −7 cm 2 .s −1 for Nd 2 NiO 4 + δ . Finally, the analysis of the time evolution of the electrodes shows that the surface cation segregation affects both the O-ion bulk diffusion and the surface exchange rates.