Abstract:It is well-known that spinning of defect-free asymmetric polyimide hollow fibers is promoted by using high polymer molecular weight. On the other hand, effects of polymer molecular weight on microstructure and separation performance of dense film 6FDA-based polyimide membranes relevant to sheath layers of composite membranes are less well-explored. In this work, gas sorption, diffusion and permeation of CO 2 , N 2 and CH 4 for 6FDA-DAM dense films are considered for 45 kDa and 176 kDa weight average molecular weights. Such molecular weights are relevant for practical hollow fiber spinning of membranes. Earlier results for polystyrene samples show similar trends in dual mode sorption model results like those noted here for the 6FDA-DAM polyimide case; however, effects on permeation like those considered here were not addressed for the polystyrene case. Here we also address actual pure and mixed gas CO 2 and CH 4 permeation and show higher free volumes, higher gas permeability but lower 50:50 CO 2 /CH 4 selectivity associated with the higher molecular weight sample. Analysis using the self-consistent dual-mode sorption and transport models help understand the observed trends. Our results suggest denser packing of polymer segments exists in the Henry's law environment of the low molecular weight sample. Moreover, the higher polymer segmental packing in the Henry's law environment suppresses CO 2 plasticization with a dual-mode microstructure controlling separation performance and plasticization behavior for this important member of the 6FDA polyimide family. We show evidence of effects of charge transfer complexes as possible main features in these trends. These dense film results help guide future work on dense sheath layers on composite hollow fiber membranes.

Effect of Phase Morphology and Interfacial Strength on Barrier Properties of High Density Polyethylene/polyamide 6 Membranes

Preparation of High Density Polyethylene/polyethylene- Block -Poly(ethylene Glycol) Copolymer Blend Porous Membranes Via Thermally Induced Phase Separation Process and Their Properties

Porous membranes modified by hyperbranched polymers II.Effect of the arm length of amphiphilic hyperbranched-star polymers on the hydrophilicity and protein resistance of poly(vinylidene fluoride) membranes

Effect Of Polyethersulfone On The Mechanical And Rheological Properties Of Polyetherimide-Modified Epoxy Systems

Effect of Morphology on the Properties of High Density Polyethylene/Polyamide 6 Composite

Morphology and Oxygen Barrier Properties of Layered HDPE/PA6 Blends Through Two-Step Approach

Study of Compatibility Between Laminar Structure and Barrier Properties of Polyethylene/Modified Polyamide Blends

Structural and Barrier Properties of Compatibilized PE/PA6 Multinanolayer Films

Effects of diluent content on the crystallization behavior and morphology of polyethylene membrane fabricated via thermally induced phase separation process

STRUCTURE AND PROPERTIES OF (PP + EVOH)/PP BARRIER MATERIAL PREPARED BY MICROLAYER COEXTRUSION

Adhesion and Delamination Failure Mechanisms in Alternating Layered Polyamide and Polyethylene with Compatibilizer

Structure and Oxygen‐barrier Properties of (linear Low‐density Polyethylene/ethylene–vinyl Alcohol Copolymer)/linear Low‐density Polyethylene Composite Films Prepared by Microlayer Coextrusion

Effect of PEG Additives on Properties and Morphologies of Polyetherimide Membranes Prepared by Phase Inversion

Insights on Influence of Polymer Molecular Weight on Gas Sorption, Transport and Plasticization in Glassy 6FDA-DAM Polyimide Membranes

Effects of the Extractant on the Hydrophilicity and Performance of High-Density Polyethylene/Polyethylene-B-Poly(Ethylene Glycol) Blend Membranes Prepared Via A Thermally Induced Phase Separation Process

Hierarchical structure and properties of high‐density polyethylene (HDPE) microporous films fabricated via thermally‐induced phase separation (TIPS): Effect of presence of ultra‐high molecular weight polyethylene (UHMWPE)

Membranes of Amphiphilic Polyamide 1012 Prepared Via Mixed ‘Non-Solvents’ Evaporation Induced Phase Separation

RELATIONSHIP BETWEEN INTERFACIAL POLYMERIZATION MONOMER STRUCTURE AND SEPARATION PROPERTIES OF PPESK BASED COMPOSITE MEMBRANES

SURFACE STRUCTURE OF POLYAMIDE LAYER AND ITS EFFECT ON COMPOSITE MEMBRANE PERFORMANCE

Preparation of Polyethylene Microporous Membranes with High Water Permeability from Thermally Induced Multiple Phase Transitions

Ultrasonic characterization of phase morphology of high density polyethylene/polyamide 6 blend melts