Abstract:Pt or Pt-alloys are used in proton exchange membrane fuel cell (PEMFC) as oxygen reduction reaction (ORR) catalyst. It is well known that anions such as sulfate, when adsorbed on catalyst surface, can significantly impede the ORR. The impact of (bi)sulfate adsorption on ORR kinetics has been reported on both well characterized Pt single crystal surfaces, as well as on supported Pt/C catalyst in aqueous electrochemical cell. Furthermore, the reversible performance loss induced by membrane chemical degradation observed in PEM fuel cells is ascribed to adsorption of sulfate on Pt or Pt-alloy catalyst. The performance loss will become more significant at reduced Pt loading, which is desired to enable PEMFC-powered electric vehicles to be cost competitive. Therefore, a thorough understanding of sulfate adsorption on ORR is much needed. The interaction of (bi)sulfate anions with Pt electrocatalyst surface in electrolyte solution have been well documented. It is generally agreed that (bi)sulfate adsorbs on Pt(111) via the 3-fold oxygen sites. Auger electron spectroscopy (AES), coulometry, and radiotracer method have been employed by Wieckowski and coworkers to quantify the amount of adsorbed sulfate on Pt (111) electrode exposed to dilute sulfuric acid solution. It was observed that the sulfate surface coverage depends on potential and sulfuric acid concentration. Although the impact of sulfate adsorption on ORR has been extensively reported, majority of the previous work have been qualitative. Quantitative studies were very rare in the literature. Therefore, in the present work we attempt to establish the correlation between the ORR activity and sulfate concentration in the solution through the surface coverage of sulfate anion on the catalyst. The mass activity (in unit of A/mgPt) of 30%wt. PtCo/HSC catalyst was measured in a three-electrode electrochemical cell using RDE (Pine Instrument Co., USA). A silver/silver chloride electrode was employed as reference electrode which was separated from the working electrode compartment by a salt bridge. However, the potential reported in this work refers to that of the reversible hydrogen electrode (RHE). The ORR activity of the Pt-alloy catalyst was measured in 0.1 M HClO4 free of H2SO4 and in 0.1 M HClO4 solutions doped with various concentration of H2SO4 ranging from 0.001 to 0.05 mM. The anodic sweep was recorded in O2-saturated electrolyte at a rotation speed of 1600rpm and a sweep rate of 5 mV/s. All measurements were conducted at room temperature. The mass activity measured at 0.9V (vs. RHE) is shown in Figure 1 (diamonds and solid black line in the figure). The ORR activity drops from 0.39 A/mgPt to 0.33 A/mgPt in the presence of 0.001 mM H2SO4, and further decreases with the increase of sulfate concentration. The correlation between sulfate coverage on the catalyst surface and sulfate concentration in the electrolyte solution was obtained from ref. 4, assuming the adsorption of sulfate on PtCo nanoparticles follows that of the Pt(111) single crystal (Fig. 2). (Bi)sulfate surface coverage increases with bulk sulfuric acid concentration following a semi-logarithmic isotherm. Finally, a simple kinetic model was used to calculate the impact of sulfate surface coverage on ORR activity. These results will be presented.

A DFT Study on PtMo Resistance to SO 2 Poisoning

Enhanced Pt stability in MO2 (M=Ce, Zr or Ce0.9Zr0.1)-promoted Pt/C electrocatalysts for oxygen reduction reaction in PAFCs

Mechanistic Insight into the Catalytic CO Oxidation and SO2 Resistance over Mo-decorated Pt/TiO2 Catalyst: the Essential Role of Mo

Mechanistic insight into the catalytic CO oxidation and SO 2 resistance over Mo-decorated Pt/TiO 2 catalyst: The essential role of Mo

A high-performance and anti-sulfur poisoning oxygen reduction reaction catalysts derive from molybdenum-doping on PtCo alloy nanoparticles surface

Sulfur Dioxide-Tolerant Bimetallic PtRu Catalyst Toward Oxygen Electroreduction

Pt modulates the electronic structure of Pd to improve the performance of Pd-based catalytic combustion catalyst

Crystalline phase-modulated PtO x nanoparticles exhibit superior methane combustion performance and sulfur poisoning resistance: Multi-interaction regulation

Origin of Pt Site Poisoning by Impurities for Oxygen Reduction Reaction Catalysis: Tailored Intrinsic Activity of Pt Sites

Pt/C-TiO<sub>2</sub> as Oxygen Reduction Electrocatalysts against Sulfur Poisoning

Pt/C-TiO2 as Oxygen Reduction Electrocatalysts against Sulfur Poisoning

Effects of Mo Doping on Properties of Pt/C As Catalyst Towards Electro-oxidation of Ethanol

Constructing CO-immune water dissociation sites around Pt to achieve stable operation in high CO concentration environment

Impact of Sulfate Adsorption on the Kinetics of Oxygen Reduction Reaction

Study on anti-sulfur dioxide poisoning of palladium-based catalyst for toluene catalytic combustion

Modulating the Reactivity of Pt-based Catalysts for PEMFC: A First Principles Study

A DFT Study on the Sulfur Resistance Mechanism of Elemental Mercury Catalytic Oxidation over Mn-Mo/CNT

Sulfur Poisoning and NH3 Regeneration of Pt/Al2 O3 : Oxidations of SO2 , NO and C3 H6 as Probe Reactions

Theoretical investigation of H2 oxidation on the Sr2Fe(1.5)Mo(0.5)O6 (001) perovskite surface under anodic solid oxide fuel cell conditions

DFT Study on Methanol Oxidation Reaction Catalyzed by PtmPdn Alloys

Adsorption and Sensing Performances of MoTe 2 Monolayers Doped with Pd, Ni, and Pt for SO 2 and NH 3 : A DFT Investigation