Abstract:To study the mechanism of the photo-thermochemical cycle (PTC), titanium dioxide (ST) and Ni-doped TiO2 (NT) films were produced using a sol-gel method and applied in the PTC for CO2 reduction. And commercial P25 (PT) has been used as a compared sample. A comparison of CO production shows that Ni-doped TiO2 performed better than undoped TiO2 and P25. Average CO production of NT PTCs was 5.30 punolig-cat and it was nearly 3.13 times of ST PTCs' CO production and 2.28 times of PT PTCs'. Scanning electron microscopy (SEM), transmission electron microscopy (TEM), energy -dispersive X-ray spectroscopy (EDXS) and X-ray diffraction (XRD) were used to assess the crystal structure and morphology of the films. Ni element could be found in NT by EDXS and inductively coupled plasma-atomic emission spectrometry (ICP-AES), and the mass fraction of Ni was 0.54% and 0.436% which were agreed with experiments. This result of XRD indicated that Ni2+ may have high dispersion without significant change in TiO2 and Ni2+ ions were doped into the TiO2 lattice so that Ni-O-Ti bonds were formed. Photoluminescence (PL), time-resolved PL, UV-visible diffuse reflectance spectra (UV-visible DRS) and X-ray photoelectron spectroscopy (XPS) analyses were also conducted to investigate the charge transfer and reaction mechanisms on the sample surface. The incorporation of Ni into TiO2 resulted in a weaker PL intensity than that of bare TiO2, which suggests that the introduction of Ni into TiO2 effectively suppressed the undesirable recombination of electrons and holes. According to UV-visible DRS results, the E, of PT is approximately 3.07 eV, which is smaller than that of ST (E-g=3.23 eV) and PT (E-g= 3.20 eV). The narrower band gap of NT indicates that NT absorbed light with a wider wavelength range than that absorbed by ST and PT. By XPS patterns, the increase of Ni+/0 and Ti3+ indicated that the Vo may have been produced on the bond of Ni-O-Ti after UV illumination, and oxygen vacancies (Vo) have been consumed after thermal step in PTC. Density functional theory (DFT) calculations related to the anatase (101) surface of TiO2 and Ni doped TiO2 was performed to verify and provide guidance for enhancing the PTC mechanism. Single and second Vo formation energy have been calculated. The Ni-doped surface exhibits better performance than the undoped surface in the first step in PTC, because of its lower Vo formation energy which produce more Vo sites. Density of states (DOS) and partial density of states (PDOS) results indicated that narrow energy gap and impurity energy level of Ni-doped TiO2 may lead to a wider wavelength range of NT. As a result, several key factors of the mechanism have been clarified.

CO adsorption and oxidation on N-doped TiO2 nanoparticles

Behavior of CaTiO3/Nano-CaO As a CO2 Reactive Adsorbent

CO Adsorption on TiO2 Nanomaterials: Nanoparticles, Nanotubes and Nano-Surfaces

Adsorption of CO on Rutile TiO2 (110)-1 × 1 Surface with Preadsorbed O Adatoms

Theoretical Investigation for the Reaction of N2O with CO Catalyzed by Pt-Graphene

In-situ Synthesized Surface N-doped Pt/TiO2 Via Flame Spray Pyrolysis with Enhanced Thermal Stability for CO Catalytic Oxidation

Photothermal Catalysis for Selective CO2 Reduction on the Modified Anatase TiO2 (101) Surface

Nitrogen-stabilized oxygen vacancies in TiO<sub>2</sub> for site-selective loading of Pt and CoO<sub>x</sub> cocatalysts toward enhanced photoreduction of CO<sub>2</sub> to CH<sub>4</sub>

on and CO desorption behavior of Band N-doped vacancy defected nuclear graphite by DFT study

Insight into the effect of oxygen vacancies and OH groups on anatase TiO2 for CO oxidation: A combined FT-IR and density functional theory study

Nitrogen-stabilized oxygen vacancies in TiO2 for site-selective loading of Pt and CoOx cocatalysts toward enhanced photoreduction of CO2 to CH4

CO adsorption isotherms on low content Pt supported on mesoporous TiO2

C, N Co-Doping Promoted Mesoporous Au/TiO2 Catalyst for Low Temperature CO Oxidation

Molecular adsorption behavior of O2 molecules on Ni2+ doped TiO2 (001) crystal plane

DFT insights into doping and oxygen vacancy effects on CO and CO2 adsorptions over CuAl 2 O 4 spinel surfaces

Nitrogen-Doped Ni/TiO 2 Catalyst with Enhanced Activity and Improved Selectivity for CO 2 Methanation

Photo-thermochemical Cycle for CO2 Reduction Based on Effective Ni Ion Substitute-doped TiO2

Engineering Tio2 Supported Pt Sub-Nanoclusters Via Introducing Variable Valence Co Ion In High-Temperature Flame For Co Oxidation

CO Oxidation at Rutile TiO2(110): Role of Oxygen Vacancies and Titanium Interstitials

Synergetic Effect Dependence on Activated Oxygen in the Interface of NiOx-modified Pt Nanoparticles for the CO Oxidation from First-Principles

Graphite Carbon Coated TiN Nanoparticles As High Durable Oxygen Reduction Reaction Catalyst in Alkaline Electrolyte