Alkaline polymer electrolytes containing pendant dimethylimidazolium groups for alkaline membrane fuel cells

Xiaocheng Lin,John R. Varcoe,Simon D. Poynton,Xuhao Liang,Ailien Ong,Jin Ran,Yan Li,Tongwen Xu

DOI: https://doi.org/10.1039/c3ta10308k

IF: 11.9

2013-01-01

Journal of Materials Chemistry A

Abstract:Novel anion exchange membranes (AEMs), based on poly(phenylene oxide) (PPO) chains linked to pendant 1,2-dimethylimidazolium (DIm) functional groups, have been prepared for evaluation in alkaline polymer electrolyte membrane fuel cells (APEFCs). Successful functionalisation of the PPO chains was confirmed using H-1-NMR and FT-IR spectroscopies. The ionic conductivities of the resulting DIm-PPO AEMs at 30 degrees C are in the ranges of 10-40 mS cm(-1) and 18-75 mS cm(-1) at 60 degrees C. The high ionic conductivities are attributed to the highly developed microstructures of the membranes, which feature well-defined and interconnected ionic channels (confirmed by atomic force microscopy, AFM, measurements). Promisingly, the ion-exchange capacities (IECs) of the DIm-PPO AEM are maintained after immersion in an aqueous KOH solution (2 mol dm(-3)) for 219 h at 25 degrees C; a previously developed monomethyl imidazolium PPO analogue AEM (Im-PPO) showed a significant decline in IEC on similar treatment. This reduction in undesirable attack by the OH- conducting anions is ascribed to an increase in steric interference and removal of the acidic C2 proton [in the monomethyl Im-groups] by the methyl group in the DIm cationic ring. Moreover, the maximum power densities produced in simple beginning-of-life single cell H-2/O-2 fuel cell tests increased from 30 mW cm (2) to 56 mW cm (2) when switching from the Im-PPO AEM (fuel cell temperature = 50 degrees C) to the DIm-PPO-0.54 AEM (fuel cell temperature = 35 degrees C) respectively (even with the use of lower temperatures).