Abstract:TiO2-diatomite photocatalysts were prepared by sol-gel process with various pre-modified diatomite. In order to obtain diatomite with different surface characteristics, two modification approaches including calcination and phosphoric acid treatment on the micro-structure of diatomite are introduced. The photocatalysts were characterized by XRD, XPS, nitrogen adsorption-desorption isotherms and micromorphology analysis. The results indicate that, compared with pure TiO2, the anatase-to-rutile phase transition temperature of TiO2 loaded on diatomite carrier is significantly increased to nearly 900 degrees C, depending on the different pretreatment method of diatomite. The photocatalytic activities of different samples were evaluated by their degradation rate of methyl orange ( MO) dye under UV and visible-light irradiation. The samples prepared by phosphoric acid pretreatment method exhibit the highest photocatalytic activity. After 90 min of UV irradiation, about 90% of MO is decomposed by the best effective photocatalyst. And after 8 h visible-light irradiation, nearly 60% of MO is decomposed by the same sample. Further mechanism investigation reveals that the H3PO4 pretreatment process can obviously change the surface features of diatomite carrier, cause the formation of Si-O-Ti bond, increase the binding strength between TiO2 and diatomite, restrain crystal growth of loaded TiO2, and thus form thermal-stable meso-porous structure at the granular spaces. It helps to build micro-, meso- and macro-porous hierarchical porous structure in TiO2-diatomite, and improves the charge and mass transfer efficiency during catalyzing process, resulting in the significantly increased photocatalytic activity of TiO2-diatomite pretreated by phosphoric acid. (C) 2014 Elsevier B. V. All rights reserved.

Carbonization Treatment and Adsorption Properties of Diatomite with Organics

The Adsorption of Dyes from Aqueous Solution Using Diatomite

Purification and Carbonation for High Loss and Low-Grade Diatomite in Inner Mongolia

Adsorptive Behavior of Colored Impurities Generated in Aromatic Hydrocarbon Oxidation Process on Activated Carbons

Performance of Nano-Caco3 Coated with SiO2 on CO2 Adsorption at High Temperature

EFFECT OF CALCINING AND SULFURIC ACID TREATMENT ON PROPERTIES OF DIATOMITE

Study On The Adsorption Of Dyes Using Diatomite And Activated Carbon

Microstructure and Properties of In-Situ Prepared Cellulosic Biomass Carbon Based Diatomite Composite

Interface Actions Between TiO2 and Porous Diatomite on the Structure and Photocatalytic Activity of TiO2-diatomite

Effect of Calcination Temperature on Crystal Structure and Photocatalytic Prop- Erty of TiO2/Diatomite Nanoparticles

Hydrothermal modification of calcined diatomite with CaO: Effect of NaOH pretreatment

Comparison study between a series of new type functional diatomite on methane adsorption performance

Adsorption Of Anionic Dye By Magnesium Hydroxide-Modified Diatomite

Green Synthesis and Influence of Calcined Temperature on the Formation of Novel Porous Diatomite Microspheres for Efficient Adsorption of Dyes

The Effect of Alkali Treatment and Organic Modification of Diatomite on the Properties of Diatomite Composite Separators

Study on Purification & Adsorption of Diatomite

Various Morphology of Hierarchical Pore-Structured Compound: MCM-41/Diatomite and Its Adsorption Behavior for Methylene Blue

Preparation of Diatomite-Based Porous Ceramics Containing Carbon and Its Adsorption to Methylene Blue

A study on the decoloring mechanism of diatomite and its treatment on waste water

Micro-structure, Surface Properties and Adsorption Capacity of Ball-Milled Cellulosic Biomass Derived Biochar Based Mineral Composites Synthesized Via Carbon-Bed Pyrolysis

P-doped TiO_2 Immobilized Diatomite and Its Photocatalytic Performance under Visible Light