Novel in Situ Forming, Degradable Dextran Hydrogels by Michael Addition Chemistry: Synthesis, Rheology, and Degradation
Christine Hiemstra,Leonardus J. van der Aa,Zhiyuan Zhong,Pieter J. Dijkstra,Jan Feijen
DOI: https://doi.org/10.1021/ma062468d
IF: 5.5
2007-01-01
Macromolecules
Abstract:Various vinyl sulfone functionalized dextrans (dex-VS) (M-n,M-dextran = 14K or 31K) with degrees of substitution (DS) ranging from 2 to 22 were conveniently prepared by a one-pot synthesis procedure at room temperature. This procedure involved reaction of a mercaptoalkanoic acid with an excess amount of divinyl sulfone yielding vinyl sulfone alkanoic acid, followed by conjugation to dextran using N,N'-dicyclohexylcarbodiimide (DCC)/4-(dimethylamino)pyridinium 4-toluenesulfonate (DPTS) as a catalyst system. By using two different mercaptoalkanoic acids, 3-mercaptopropionic acid (1a) and 4-mercaptobutyric acid (1b), dex-VS conjugates with either an ethyl spacer (denoted as dex-Et-VS) or a propyl spacer (denoted as dex-Pr-VS) between the thioether and ester groups were obtained. Linear and four-arm mercaptopoly(ethylene glycol) (M-n = 2.1K) with two or four thiol groups (denoted as PEG-2-SH and PEG-4-SH, respectively) were also prepared. Hydrogels were rapidly formed in situ under physiological conditions by Michael type addition upon mixing aqueous solutions of dex-VS and multifunctional PEG-SH at a concentration of 10-20% w/v. The gelation time ranged from 0.5 to 7.5 min, depending on the DS, concentration, dextran molecular weight, and PEG-SH functionality. Rheological studies showed that these dextran hydrogels are highly elastic. The storage modulus increased with increasing DS, concentration, and dextran molecular weight, and hydrogels with a broad range of storage moduli from 3 to 46 kPa were obtained. Swelling/degradation studies revealed that these dextran hydrogels have a low initial swelling and are degradable under physiological conditions. The degradation time varied from 3 to 21 days depending on the DS, concentration, dextran molecular weight, and PEG-SH functionality. Interestingly, dex-Pr-VS hydrogels showed prolonged degradation times, but otherwise similar properties compared to dex-Et-VS hydrogels. The hydrolysis of the linker ester bonds of the dex-VS conjugates under physiological conditions was confirmed by H-1 NMR. The results showed that the hydrolysis kinetics were independent of the DS and the dextran molecular weight. Therefore, the degradation rate of these hydrogels can be precisely controlled.